The Simplex system is used be security as well as zone paging, they only want to be able to do the all call from the CS1000 according to the documentation i found most of the commands for this system start with the "#" sign which i find very strange. however if looks like i have it in a workable...
I can with MANO= YES
I just change the following timers in the RDB
OOD = 1
LEXT = 100
now after I get the tone, if i dial the #110 i get confirmation tone and can page if i pause for a fraction of a second between "#" and the "110"
this may actually work
With MANO = NO
1. dial 1721
2. get tone from page controller
3. dial #110
4. does not break tone, can't page
if i wait several seconds after getting the tone before dialing then it breaks the tone gives confirmation tone and i can page
still a delay
When I do an enhanced trace if i dial the "#110" after the call shows "Established" i get confirmation tone and can page.
dialing "##110" does not work
If I dial "#110" as soon as i hear dial tone, the "#" breaks the dial tone however I do not get the confirmation tone and can't page.
Enhanced...
I am having trouble interfacing to a Simplex 5110. i have programed a WAT route with a Trunk on a XUT card.
See RDB and TN below:
when i dial the access code for the route i get dial tone from the Simplex system, i need to be able to dial "#110" if it works correctly i would get a confirmation...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.