Search results for query: *

Follow those steps to clean up How to free up disk space for Service Pack installation. If during SP installation you get an error message like “There is no enough disk space on “/var” partition”, you should follow these steps to free up additional disk space. If you want to free up disk space...

Hi It is also possible in the call server. The problem is that you need to know the agent's position ID, TN or private extension. Is this information available to you?

Wich system is installed there ? Callserver or signaling server ?

Hi i saw your answer late A bit strange because active logs and traces are actually stored in the /var partition and cause a disruption. I've never seen the sda11 on our systems like this. You should go into the system with the browser and check the "Software Loads". Check if the file ".nai "...

What Hardware has you run ? CPDC? CPPM ? Login over ssh Type DF -h and present output here

The Avaya Aura Contact Center Manager Administrator (CCMA) Open Interface incorporates SOAP- and REST-based Web service interfaces that can be used by third-party applications to access certain Contact Center management capabilities provided by CCMA. And by the way i believe your questions...

I am Back Not so easy to say what else Please check configuration of CISCo System Region Configuration Check Audio Bit Rate Must be same Audio Codec as Avaya Sessionmanager and Signalinhserver G711 G729 or what ever SIP Trunk Security Profile Incoming Transport Type Use UDP and TCP...

Check Usee claa of service Must 'udi' active not 'rdi'

What release of Call Center runs ?

Look in Folder patch too There sometime forgotten uploaded Service packs

Sorry ,was out of the office Disable D-Chanel has be done overlay 96 Ld 96 Enter dis dch xx Enter Then open overlay 17 to made your change Return Overlay 96 enl dch xx Enter

We have the same configuration active. In contrast to you, we do not use standard in the routing script ( SIGO = STD) and in the D channel RCAP = TAT ( anti-trombon ) We operate the trunks with wnk/wnk instead of IMM/IMM . most often such problems occur in connection with several features. A...

Hi has you try TCP instead UDP what you setup in YeahLink ?

Thanks

A look at the error logs on the call manager could also be helpful. The recordings there are often very detailed

Hi zigmo36 Sorry the late reply You will receive this message if the application is faulty. For analysis: do you hear this message before you make a selection or after? If you hear this message after making your selection, the number may not be reachable from the call pilot. In this case I...

Solved

AWIS2 for IP DECT

If you still have a PCMCIA with software, you can reset the passwords using the tool menu

Hello zigmo36 Your application has not been completed. What is your application doing? An announcement?