Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. imtiazbajwa

    HiPath3800 CBSAP interface down when STMI2 card is installed

    Suzuki Yota, configure the IP address for STMI and Hipath 3800 separately in same subnet. Make sure both IPs are reachable from your PC. Access Hipath 3800 through its IP address via manager "E" and STMI by internet explorer. the IP Access configured to "HIP forwarding
  2. imtiazbajwa

    Openstage T series

    is there any tool for firmware/software recovery for Openstage T series. we can upgrade via manager "E" if the set is operational. I need to recover the Openstage 15 T flashing/dead "lost its firmware". thank you in advance
  3. imtiazbajwa

    OSBiz SLMU

    AOA I have an issue in Openscape Business X8, Hardware SLMU, OSBiz_V2_R4.1.0_028, country version international. issue is with TDM phones Openstage 40T with software V2R1.2.0 and optipoint 500. " [u]the incoming call sometimes we pick up the handset, speech established, ringing continue with...
  4. imtiazbajwa

    Openscape Business X8

    Hi Dear, SLMA24 (Q2246) requires "ring generator" for ringing current, Q2191 uses on board built ring generator, ringing current is available, it rings all type of analog telephones. we are facing issue when we pick up the call connected to Q2191 port via Panasonic telephone KX-TS560MX, the...
  5. imtiazbajwa

    Openscape Business X8

    Hi all, I have an issue with openscape business x8. I have analog subscriber modules SLMA Q2191, SLMAE and SLMAV. I am using Panasonic telephone KX-TS560MX. I am facing the issue for internal calls, connected with SLMA Q2191 modules. the internal call automatic hold when we pick up the phone...
  6. imtiazbajwa

    Hipath 3000 with HG1500 interconnecting problem with Unify V2x8 system.

    Only networking license required in OSB (which you have) add trunks to networking trunk group 16 you are create "Nodes" for Hipath 3000 in voice gateway (Expert mode) activate LCR all the routings to Hipath system via trunk group 16 "networking" In Hipath 3000 V7 to V9 add new nodes for OSB...
  7. imtiazbajwa

    HD Drive letter assignments in Phonemail

    I am facing problem in openscape business X8 v2. I upgraded from Hipath 3000 V9. the problem with PRi trunk DIUT2, does not synchronize with another hipath 3550 V9. in openscape bussiness X8 V2 I have licenses S2M qty 28. it shows reference clock when I define Hipath 3550 as master, however when...

Part and Inventory Search

Back
Top