Search results for query: *

UPDATE: Alright, so I decided to go Client-to-Gateway instead of using the Easy VPN Group Option. I'm now using FQDN for IKE ID type, and I have programmed the protected network as 192.168.1.0/24, and the tunnel will establish, but same result. I can see the router building the routes when...

Thanks for the suggestion, unfortunately I've tried this, I programmed 192.168.1.0/24 into the Protected Network field, but when I try to establish the VPN tunnel I get "IKE Phase 2 No Response." :(

Hello All, I am trying to use the built-in VPN on the 96XX series sets (tested on a 9608, 9611, and 9621), with a Cisco RV320 Dual WAN VPN Router. I've scoured the web trying to find a resolution to my issue, but I can't seem to find anything. I have configured the VPN settings on the RV320...

So internal twinning will not work then. So the real only way to accomplish this is to set a Leave action on the group I've created with a Transfer to: User Mailbox in Voicemail Pro then?

The only issue with the internal twinning I can see, is that from my experience, and I could be wrong, the extension that is being twinned to comes up as busy if you attempt to call it from anywhere else. This polycom has it's own DID as well, so would this still work, or would the calls coming...

So setup a hunt group containing the two extensions, and instead of using the HG Mailbox to answer, have it direct to the users individual mailbox in VMPro? I'll give it a shot, thanks.

Answered my own question about the Bridged appearance, it will only let you program a bridged appearance of another analog set, not the 9608. Any other way to accomplish this, without going the hunt group route?

I'm trying to figure out the simplest way to set this up, I know I could just throw both into a hunt group, and have the incoming call route ring that group, but I want the users desk set voicemail to answer instead of the hunt group voicemail. User wants his incoming DID to ring simultaneously...

It always followed the pilot line in the line-over-line, moved that line from 061 on the CTM8 to 064 and it would still ring at random. I pulled CDR reports on that system this morning, and there were no calls from about 4:20pm on, all the way up to this morning until the location opened again...

I have a bit of a strange issue that I'm not sure how to address: This started yesterday, the system is a BCM1000 with 2x DSM32, and 1xCTM8. 5 Analog lines connected using a Line-over-line setup from TELUS. They are encountering "Line 1" ringing randomly, and sometimes constantly, and when...