Hi, thanks for the comment.
I have figured it out. I just needed to increase the queue-limit to max and also the tx-ring-limit to 160 based on the computation guide
from this link...
Hi Guys,
Need your help. We upgraded our bandwidth speed to 100mb down 100mb up, but our ASA 5505 is only getting 30mb-40mb down and 40mb-50mb up. I have also remove the traffic shaping in the interfaces.
please see below current running configuration, I removed the IP addresses and Access-list...
thank you very much. and my apologies for my ignorance, I am new to this.
what about this error:
"148102070mS CMARS: FindActiveARSByGroupID GroupID=91 - Not Found"
and
"148102071mS CMARS: LINE with group ID: 91 HAS NO CHANNEL: 34 - ATTEMPT OTHER TARGETS"
is this also related to VCM?
thanks...
thank you!
I fund it. I have 18 VCM and SIP license is for 20 lines.
would running out of VCM can trigger a message to display Waiting_for_line in the users Phone?
thanks again for help.
would think that we have the VCM cards.
we have two locations each with 1 IPO controller and 3 IPO modules
and we have total of almost 100 users.
the issue only happens once. for 30 minutes and then it went back to normal.
maybe all the VCM channels are used up during that time?
thanks.
i have this licenses installed in our System
License Type Available Instances
Prefered Edition (Voicemail Pro) Unlimited
Phone Manager Pro IP Audio Enabled (Users) 2
Prefered Edition Additional Voicemail Ports 4
Phone Manager Pro (per seat) 3
IP500 VoiceNetworking Channels 12
SIP...
ah ok. I have actually contacted the provider and they are looking in the issue, but at first they are insisting that it was an internal issue.
so i thought is was a license fully used up issue because i saw in the IP Office System Status > Service Errors
"The following System resources are in...
yes the codec is correct. it was actually working fine, it only happen this particular time where in for almost half an hour, we cannot call outside. and after that, all calls went to normal.
Hi There,
good day. i am new to IP Office 500 and SIP Lines.
few days ago, we have an issue with our Phone system when people tried to call outside, they got Waiting for Line displayed in they AVAYA 5410 phone.
i check the System Status, and i got an error: "No Free Channels were available...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.