Search results for query: *

Hi mevasquez! Boot your system in maintenance mode by typing hpux -lm at the isl prompt. Then activate your volume group but don´t mount any filesystem. After that put in: # fsck -F vxfs -o full -y /dev/vgxy/lovln Hope this helps regards CL

Thanks for your fast reply. I ´ve already checked this. There´s no running job. In the moment i try to recover my lpspooler configuration from a tape. Usually removing SCHEDLOCK- and FIFO-file from /var/spool/lp directory takes effect, but in this case it doesn´t work. Have you or anybody...

Hi! I´ve got a C3600 with HPUX11 and there are many printers in the lpspooler. The problem is every time I start with lpsched i get the message "scheduler is running". so far so good. But the scheduler dies immediately again. What´s the problem. Please help! Many Thanks carsten p.s...

I think this is just HP-UX. ;-) Other Unix-/Linux-Systems don´t have problems with these configuration.

Thanks a lot!!! That was it. The last range is also invalid. But why? Isn´t it wastefulness? Carsten

The IP-Range is 192.168.1.0 - 7. Host-Address is 192.168.1.4 I´d read that ndd perhaps fix this problem. But I also readed that ndd includes a security problem. Are there any other solutions? Thanks in advance! Carsten

I tried to assign 255.255.255.248 Netmask on my HP-UX11 Machine. But it´s not functional. I get the following Error message: lan0 interface: ifconfig: ioctl (SIOCSIFNETMASK): bad value Any ideas?

Hello Everybody! On several Systems I got a message from EMS. See the fragment down below. On all Systems the same HW-Path (CD-ROM Device) is affected. Any ideas? Thanks in advance Event data from monitor: Event Time..........: Fri Dec 6 08:06:22 2002 Severity............: CRITICAL...

I found out, that the apache become started on both Nodes if I put in the following command: cmmodpkg -e -n node1 -n node2 packagename But I don´t know why! Please help!

I´ve got a MC Service Guard Cluster and try to run the Apache2 Webserver in a highly available package. The package is configured without any errors but if I start the package I´ve received the following message three times: (226)Address already in use: make_sock: Could not bind to address...

hi adubla, i don´t know where to download this software, but may i can send you the required software as a sd-depot via e-mail. it´s not so large.