Hello all,
What would be the colors/pinouts to go from a 25 pair female amphenol on the G3r to an RJ45 on the Shoretel side? What I made up and seems to have problems is:
RJ45 Amphenol
White/Blue Purple/Orange
Blue/White Orange/Purple
White/Orange Purple/Green
Orange/White...
Hello all,
When I try to configure a TN2313AP with Signalling Mode set to ISDN-PRI I get the error "Requires TN2242, TN2464, DMM1, TN464C or later release circuit pack" What is going on? I thought that this was a new circuit pack than any of the ones referenced too in the error.
Thanks!
Hello all,
Is there a quick way to get a station count by type-analog or digital-without counting each one individually? Maybe ASA has a way but I can't find it.
Thanks!
Greetings all,
Can the power supplies in the B through E carriers be replaced without powering down the entire cabinet? Been awhile since I replaced one.
Also, can the pins in the back of the 630DA1 supply be changed to match the pinout of the 630DB1 and in effect turning a A into a B? A tech...
I've been working with the Definity since the G3iV3 days and even worked with a System 85 at one point, just wondering if anyone has an educated guess as to how long these systems may be viable in the market? The last I checked CM4 was out and there many have been upgrades since them.
I've seen...
Hello,
My dialplan currently has 9 set as an extension, length 4 digits. I need to break it out so that:
90, 4 digits, extension
91-96 as above.
97 4 digits aar.
It won't take as the message is that "A single digit entry is already on screen with the same first digit."
So when I try to delete...
Hello all,
If a carrier power supply fails, either A or B, do I have to power down the entire cabinet to replace it? Or just unplug it at the front power connection, unlock and remove?
It looks like the only difference between the two supplies are the pin placements at the center of the...
Thanks for the reply.
I have two of the MO disks that are returning errors when in place. When I "test rem 1a (or 1b) long" I consistently get a fail on test 811. This fail follows the disk whichever drive it is in.
Any ideas?
Thanks!
Hello all,
My original disks are wearing out and I am ordering generic new ones. They are 640mb.
Will they need to be formatted before use? I didn't see a command to do that and I have dadmin level access. All I saw was "format disk" but no other options.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.