Search results for query: *

Hi all, So we made the following changes on the IPO and voila, calls get through either way and we could hear each other clearly: - a default route of 0.0.0.0 / 0.0.0.0 / <gateway> / LAN 1 was added - Codec set to AUTOMATIC And below is the config I have on my CME: ! ! voice service voip...

Cisco 871 router. I did change the vlan settings from vlan101 to vlan1 while i was troubleshooting because my end devices were always on vlan1, but that didnt resolve the issue either until i removed those 3 commands.

Hi, Where did you add the ip routes (though sounds like on the IPO) and why 3 ip addresses?

Hi Sean, I was outta the office on Friday, baby and wife needed some helping hand. Will be back at the office tomorrow and will try out your suggetions as regards our emails. You didn't get back to me though as regards my CME config and also how to resolve the 10 sec dropped call issue. Will...

Hmmm, thats odd... "...i would try using routes for the voice" >>> how do you reckon I do this? Will this be on the IPO or CME? "The 30 secs disconnect means that the IPO does not know where to send backthe voice and then disconnects" >>> so what do you reckon I do to resolve this? Regards, Femi

Hi, I just resolved the problem. I reconfigured the Vlan interface like below and it worked: interface Vlan1 description LAN_FW_INSIDE$FW_INSIDE$ ip address 192.168.1.254 255.255.255.0 no ip redirects ip nat inside ip virtual-reassembly ip route-cache flow I guess it has something to do...

Hi, Thanks for both files, already have them though. The problem now is that there is no sample config for my exact scenario, IPO and CME. I made some progress though. I setup the H323 config on the CME and I can make calls to phones controlled by the IPO from the CME phones. However, when the...

Hi, Been trying to configure a trunk between Avaya IP Office 5 and Cisco Call Manager Express 7, both share a common network, hence have IPs within same subnet on specific interfaces. Can anyone please help with sample working configs to get this up please? I have been on this for quite a...

Hello, This is not the first time i will configure over the internet access to a local server but this particular one is giving me a major headache and i thought to share the config with anyone who can help ppoint where the problem may be. While my NAT transalations seem to be working, when i...