Search results for query: *

I'm told that these have to have a controller, but they can be made standalone. Does anyone know how to do this? I've got an 1140 and an older one. The older one, when I used a wireless sniffer it didn't detect a broadcast and when I log into the console, lines and line keep rolling by. It's...

Doesn't debugging/logging use a lot of router resources? It looks like debug is on and the way I understand it is that debugging will slow router. I am no expert. Just started CCNA studies.

The NAT ACL was wrong, it's working now.

As I have said above...nothing has changed since last night. All interfaces are up/up, so it's not a cable. The default gateway is set, but it says no gateway of last resort .148 is directly connected to .129, but it doesn't say that in "show ip route" If I take the 2801 out of play and...

Well, the default gateway .129 is my modem and is directly connected to .148 (my fa0/1) cannot ping past the fa 0/1. ACL is config'd the exact same as last night and it worked. 8.8.8.8 is just google I think that I put as DNS info on the 2801. The problem has to be with the 2801 cause if I take...

No one? If I take the 2801 out of the loop and connect my laptop to the Comcast modem I can get onto the internet with the exact same info as configured on the 2801's fa 0/1 int.

Router was working last night on my Cisco 2801 and this morning it was not. Brought the 2801 home to configure it for the office. Configuration hasn't changed since last night, so I have no clue. I re-enabled my wireless card and connected to my wireless linksys and I can get onto the internet...

Ru55ell, did a no ip virtual-reassembly command and it works great now. Thx!

Anyone else? I'm getting ready to go to the office to implement "Ru55ell" solution and would appreciate other suggestions or confirmations. BTW,Ru55ell thank you and will let you know if it worked. I'm thinking about bringing it home and just change the address info and see if it works on my...

The 216.37.xx.37 is the addy for the csu/dsu and .38 is the WAN side on 2801. I didn't see a difference between the line I had for the static NAT and the one you just gave. Am I missing something? Other than that, do you see anything else wrong with my config? I excluded dhcp addys .1-.10 so...

Yea, I thought I needed that command for remote access to the server.

I'm helping a friend with his new small office network. Replacing linksys home router with Cisco 2801. He has x2 bonded T1''s to a Cisco 1700(csu/dsu)216.37.xx.37 not config. for router. This is the ISP's equipment. 1700, currently connects to the linksys (216.37.xx.38). The 2801 will simply...