There is no entrys on the listed directory number.The inbound calls are all done on the trunk group.There is no console programing,the receptionist is using a 6424d+ phone as the console.
I did read that article.Thank you for replying.Maybe i did not state my problem correctly.Ill try again.In a trunk group there is 3 places you can direct a call to a night service.On page 1 which i think will direct anything incoming on that trunk group to night service.Also on incoming call...
I have a Prologix,3.0 system.When any extention is entered in the Night Service field on the trunk group form and you call the main number,the calls go to the night service destination even when the system is in day mode.I need to be able to toggle between day and night mode by pressing the...
Iam trying to send a station user name from their name field outbound instead of their number.On the trunk group,i have send name"yes".I have their number in the isdn public unknown field.Is this correct and what am i missing.Thanks
If i do a list surv command,the field for last trans saved is blank.Ill pursue the blocked port.What doc would i search to find the port that is being used?Thanks
Restrict Local Procedure Access
## Controls whether local (dial pad) procedures can be
## used to administer the telephone.
## 0 means local procedures can be accessed from the
## telephone.
## 1 means local procedures can not be accessed from the
## telephone.
## CAUTION:Be...
I have many 4600 IP sets,and i cant reset the IP parameters on them.None of the mute features work,i do not get a * to reprogram them after a reboot.I have downloaded the latest 46xx file.Is there anything iam missing?Thanks
I have a s8400 running 4.0 CM.Two 8300 LSPs running the same or higher software.Times on all servers are the same.I can ping both ways.Both LSP have registered to the primary.I can sa tr all or sa tr lsp and it says success.If i do a list st on lsp its blank.Could there be a blocked port and...
Iam working on a G3csiv6 system and can't use the list trace command.Do i need to turn that command on or was it not available in that release software?Or is there a different way of tracing calls?Thanks for anyhelp.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.