OPT 81 /cs1000
I have a shelf I would like to remove. All line cards have been outed and removed except for the DTR card. What need to be done to remove this card and out this shelf so it can be removed?
I am needing some assistance on changing my outbound local PSTN calls. I believe that changing the ROUT number in the RLI will point the call to the proper route. But i need to keep the access code "9" on the digits sent. The calls are now going to another pbx to route them to the pstn.
I have a cisco call mamager tied to my CS1000 MG 5.0 with 2 qsig pri's. We have 2 pri's connecting the CS1000 to the pstn. When calls come to the nortel from the cisco the caller id and number are correct. When the cisco calls out to the pstn the caller id is being changed to the main number...
I have found a new issue, The cisco system is sending me XXX-481-7789 on a outbound call to the pstn. The nortel is changing it to xxx-482-2345 (which is the main number here).
I not sure where it is inserting this number. Any help would be great.
We have tied a nortel cs1000 5.0 (opt 81) to a cisco call manager with 2 qsig pri's. Every thing is working between them fine but we are now getting the following error none stop. Does any one know what might be causing this.
AUD083 070A93E0 00000C87 00000000 0000DD80 00000000 00000F01...
that makes sence now. yes 18 19, 20 21, 22 23, 26 27, 30 31 are all open. so ill put the card in slot 2 and make it loops 20 and 21? I need to label the slots with the loop numbers.
VERSION 3621
System type is - Communication Server 1000M MG/CP PIV
CP PIV - Pentium M 1.1 GHz
RELEASE 5
ISSUE 50 J +
How do I print the card inventory in ld 117
I am needing to add new loops for a Dual PRI card. I am not certian which loop numbers to make them (I think I need to add 2 loops?)
Thanks for any help in advance.
CEQU
MPED 8D
TERM
REMO
TERD
REMD
TERQ 018
REMQ
SUPL 004 024 028 036
040 044 V100 N252
SUPC
SUPF 052...
Can a 2 port fiber card be swapped with a 6 port fiber combo card with out changing the programming. I have a spare 6 port combo card that i want to put into a MICS 7.0 that I am going to be putting a DTI card into and possibly adding a 8 port analog station module also. The combo card will do...
We have a MICS 4.1 norstar system that we are wanting to change the service on to a pri. There is currently a T1 going into the system with DID numbers. What all is involved to change the system to allow the Pri to work and what new cards and keycode are needed to do this
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.