Hi Guys!
Is it possible to disable telnet/ssh and web interface services from IP phones (DBC 422 and 425) for the purpose of preventing remote access?
Thanks.
Thanks master inlsp05!
I found this thread (https://www.tek-tips.com/viewthread.cfm?qid=928728). My system has LBP22 magazine. CNREC solved the alarms.
Living and learning always.
Hey Guys!
Anybody could say if there is difference between the limdisp for LBP22 and LBP20 magazines?
I installed a new system, but it is showing the 102 code alarm. I know DC-DC it's okay. I executed LSFTI command. No problem. I think the system is confused.
Thanks in advance.
For 1/4 connectors on both sides:
abc abc
... ...
cde cde
... ...
fgh fgh
... ...
ijk ijk
The cable pinout is straightforward. Each letter corresponds to a connected wire.
Hi guys!
I have a problem with DISA outgoing calls. The DISA is working, I can to dial, but at the destination the number of A appears 00. How can I change to a valid public PBX number.
Thanks.
Come on...
How many version of niux does exist?
1)The menu of the first version I found:
niux > help
bdsvi: set NIU board to service mode
bdsve: end service mode on NIU board
bdsvp: print service mode status of NIU board
tdrvstat: tty driver status information...
Hi Guys!
I need to change the location of the rectifier that powers the MD110 BC9. How do I safely shutdown the PBX and then turn on?
I will need to replace the cables that connect the rectifier to the CLM magazine.
I have 5 LIM, 1 GSM and 5 CLM modules.
Would the procedures be similar to...
Hi guys!
I am trying to activate the ethernet NIU interface but it doesn´t work. Is there a specific license to use the interface?
I set up the configuration of the port with IP, gateway and mask. The port on the switch blinks but I can´t to ping the NIU.
On the mode NIUX I can ping the own...
Hi michelepin!
I solved this problem changing LSU board and following the steps below:
1)Block LIM traffic with BLLTI:LIM=X
2)Turn off the LIM X
3)Change LSU board
4)Turn on the LIM X
5)Deblock LIM traffic with BLLTE:LIM=X
Previous test
LSFTI:LIM=1;
LIM SWITCH FUNCTION TEST RESULT FOR LIMNO...
Hi guys!
Here again for help. Anybody knows how can I change the answer group call pick up code service?
It´s set the code 8, but I need to change it.
TYPE OF SERVICE CODE SERVICE CODE
ANSWER GROUP CALL PICK UP 8
Thanks!
Yoda1 (himdp)[yoda] and Yoda2 (fcpli)[yoda],
The numbers are correct. It's just a coincidence.
The first 21 is the code of the carrier, the second is the area code and the third is part of the PBX main prefix (2101).
Again, thanks a lot!
Dreaming of being a padawan.[lightsaber]
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.