Has anyone tried the Nortel door phones on Office? If I remember right the norstar system saw them as a M7208 phone but there was a feature code to access the configuration.
mforrence- in this case the Line Appearance key isn’t lighting, just the spkr button. If you dial a number the screen indicates IMCOMPATIBLE
Sorry sizbut I should have mention that. Software 3.2(67)
Thanks
IP Office 403 System. Using 4412D+ phones.
I have configured several IP Office 500 systems with no problems. I have recently had put a IP403 system into service and noticed that when I configured the button programming for each set to have 4 line appearances, the phone sets do not allow you to...
I have had the same problem before. I replaced the wiring and then made sure the pair 3 and 6 are not connected to the phone. That solved the problem for me. Try a 2 conductor cable from the jack to the phone instead of 4 conductor.
I have 3 M7310 phone in a restaurant that is very noisy. The staff is complaining that the volume is too low on the phones to hear. I have explained to them how to turn the volume up on the phones. Is there a way to keep the volume on high? It seems to default middle way every session. Does...
Sorry I didn’t explain well. Someone in the office is on the phone with someone else using an outside co line. Lets say Line 2. Someone else in the office would like to talk on the phone as well just by hitting the Line 2 button that appears on the phone as well and join in on the...
Where would I go to configure the system to allow two phones to use the same external co line that appears on both sets at the same time? Currently the system will not allow but one set on the same external line at a time. IP Office 500 V1 R5. Thanks.
I loaded Manager on another PC with XP and the phones loaded properly. I will reinstall Manager on the windows 7 PC and try it again as the file server.
Thanks
I have several new (old stock) 4624 IP phones. I have set up one of the phones which attempts to load but will get to loading and save b20d01a2_3bin then restart. Then will start all over again. After several loads it will display File Transfer Failed.
Last two lines in the TFTP log
Tuesday...
Hi, The Phone is saving the settings file then loading to flash but it will only go to 67% and then stop loading.
Counts up to about 60 secs then the phone will display Hardware Failure Cannot save file. Any suggestions?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.