Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Clip203

    x450e-48p Stuck in POST

    Call Extreme and Replace it. It's a x450e-48p. Extreme has a Life long warranty for all Edge switches. It's just a Return and Replace. I'm a Extreme Tech :)
  2. Clip203

    IPROUTE for only 1 vlan?

    How many vlans do you have with ipforwarding enabled? If none are you can easily enable ipforwarding on both vlans and add IP's to forward between them. If you have other vlans with ipforwarding you will have to create new VR's but Extremeware doesn't support the creation of a new Vr
  3. Clip203

    x450e-48p Stuck in POST

    If you cant get into the bootrom or bootstrap it will need to be replaced.
  4. Clip203

    Port Mirroning in extreme 68

    Yep is sure is. u just cant do it across modules
  5. Clip203

    Dhcp Extreme

    If the DHCP works for a PC and not a Phone it looks like the switch is configured correctly. Extreme DHCP doesn't always work for every device becasue it was added to the code for testing and was not made to support a production network. I would check to see if there is a new firmware for the...
  6. Clip203

    problem with BD8810 POE card

    How much power are you using? #show inline-power Are you getting any POE errors in your logs? Extreme switches default to allowing 70% for POE power. You can change this to 90% with the below command. #configure inline-power usage-threshold 90 Let me know if this helps.
  7. Clip203

    Enable web

    it's enable web http or enable web https
  8. Clip203

    Black Diamond Error after one PSU failed

    yes it is a CLI command. but my mistake i see that it is a 6808 and it's not EXOS. show power is a EXOS command. I would run diags. MSM-A looks like it could be failing. I would run it with only with MSM-A in the Chassis. If the MSM failed over the logs could be false positive. You could...
  9. Clip203

    ACL TELENT

    entry block_TELNET { if { protocol 6; source-address 192.168.11.10/32; destination-port 23; } then { deny; } } save this to a .pol file and add the .pol file to the vlan
  10. Clip203

    Lost password

    You can also use the back door password :)
  11. Clip203

    BD XOS 12.1

    entry block_TELNET { if { protocol 6; source-address 192.168.11.10/32; destination-port 23; } then { deny; } } Protocol 6 is TCP Welcome :)
  12. Clip203

    Alpine 3808 & SMM 54014 limited mode

    clear log diag-status is all you need to do. and reboot
  13. Clip203

    Black Diamond Error after one PSU failed

    Try doing Show Power Budget and see is your N+. this is redundant. 1. Did the MSM fail over? 2. You can try failing over to MSM-B and running Diags on A this is non-intrusive to check for HW failure. Welcome :)

Part and Inventory Search

Back
Top