Search results for query: *

Hello, We can send fax through DID (with the service provider) to any PSTN line with no problem. Also, we can receive fax from a GSM modem (in area where there is no land line, a sim card with fax/data feature is used with the GSM modem that gives a fax/telephone port) connected to a fax...

Hello everyone, we have a nortel 81c system release 5.0. We have a problem with one of the rings (ring 1 is OFF now and ring 0 is driving FULL). Three months back we have a FIJI0037 error comming the system and they installed some patches, and increased the number of call registers to 20000. Two...

thanks, we installed a clock controller in the 2nd cabinet 8 0 and created the cc in ld 73: mgclk 4 0 2 pref 4 0 2 sref mgclk 8 0 2 pref sref . . the status of ssck in ld 60 ssck 4 0 enbl clock active clock controller - locked to slot 2 pref - 2 sref - ssck 8 0 enbl clock controller - free run I...

Hi, I have two option 11c cabinets. the 1st has cppm & MGC plus 1 PRI with clock controller & D-channel. the 2nd cabinet only has 1 MGC and 1 PRI without clock controller. I am getting DTA301 error every 3 minutes that cause the loop to go down when the counter reaches 255. Questions: what is...

Hi johnpoole, it worked. my bad, i reversed the order of the extensions !! so it should be key 0 hot d 4 (destination ext) (local ext) thanks

site A: m3902 key 0 hot d 4 (site B) so there is no extension to be reversed in site A because KEY 0 HOT D 4 (SITE a EXT1) (SITE A EXT2) is valid only within the same site only but when tried KEY 0 HOT D 4 (SITE B EXT) (SITE A EXT) for the tie didnot work

Yes, one way is working. site a can ring site b 1234 ext. but we need a way to let 1234 also dail site a ext ??

Hi everyone, we have two option 11c connected together via E1 PRI (TIE). we need to program a two-way hotline between the two sites. we where successful to program a two way hotline within the same site extensions, however when we used the same logic for the TIE didnot work: KEY 0 HOT D 4 (SITE...

hi everyone, I am getting dta301 error message on nortel 81c pri that is connected to a remote option 11c through E1 link. the link was tested and found no errors, but still getting the error almost every 30 seconds. on that remote 11c i am getting dta300 error message. the stat of loop in ld 60...