Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
cbwfq on multilink laboratory setup
To answer my own question, i think it depends on the hardware. Ive read that a WIC-2T on a 3745 supports 8Mbps, and a HWIC-4A/S on a 1841 only supports 256kbps. I knew that the "bandwidth" command on an interface does not change the maximum speed the interface supports. I just didnt realize that... -
cbwfq on multilink laboratory setup
Thanks for the reply, Minue. I will test the setup again using standard link, with lower link speed. Sorry, for the ignorance, still a newbie in the networking world. =) So, however high I set the bandwidth and clockrate for the interface, the maximum speed will still be at T1 or E1? Im a... -
-
cbwfq on multilink laboratory setup
Ok, I think I understand. But why does my download time halved when I increased the BW from 2Mbps to 4Mbps? Also, why is the serial link limited to T1 speed, when I can get a leased line of higher bandwidth, say E1? show int s0/1/0: Serial0/1/0 is up, line protocol is up Hardware is GT96K... -
cbwfq on multilink laboratory setup
IC. But its just a lab setup. I used a DCE/DTE cable to connect the two routers. I configured the BW of each of the serial int to be 4Mb. Sorry for missing out this info. show ver: Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.3(8)T11, RELEASE SOFTWARE (fc1) Technical Support... -
cbwfq on multilink laboratory setup
3Mb? Why? When I measured the bandwidth using PRTG, I got 8Mb. I monitored 3 Ports of the 3745 - multilink1, fa0/0 and fa0/1. I got a constant 8Mb on multilink1 and varying BW on fa ports depending on the number of ftp sessions. I have one ftp session between 10.88.0.1 and 10.89.0.1. And 4 ftp... -
cbwfq on multilink laboratory setup
or maybe am I not generating enough traffic/congestion to trigger CBWFQ? -
cbwfq on multilink laboratory setup
Hi there. I have a multilink laboratory setup, composed of two Cisco routers back to back. One is an Cisco ISR 1841 and the other is a Cisco3745.I configured both of them for multilink and setup a cbwfq for qos. But it appears that (my monitoring tool is PRTG, btw) the routers does not...
