Search results for query: *

Success! Thanks for your help!

hawks - Yes, the protocol in the MICS is set to NI-2. Thanks again both of you for your help. I'll post in the AM to let you know how it went.

UPDATE: I just realized that the Nortel pinout diagram was OF COURSE for the jack, NOT the plug. How could I miss that?? I'll remake my cable and test it in the AM. I'll let you know what happens, though I'm guessing it'll work!

That's actually the custom cable I tried last night after looking at the pinout diagrams. Unfortunately, it didn't work.

Yes. I don't have a test system to try this on, so I test it in the early AM and late PM. Currently (i.e. during business hours) the PRI from the telco is plugged directly into the MICS. I just got off the phone with Adtran support. They seem to think it should be a straight through cable...

I have 2 T1/PRI cards and an FXS Card. Net1 is the PRI coming in from the telco. Net2 goes to the MICS. FXS goes to my fax server. Net2 interface config is attached/linked in my original post. I have the FXS card set to accept numbers 278-1XXX and pass the DID digits to my fax server. When...

I'm trying to use an Atlas 550 to split off some DIDs to a fax server with analog ports. Actually, that's the part that working fine. Great, really. The trouble is, I cannot get the second T1 port on the Atlas to connect with the T1 port on my MICS. I believe PTerrell had some success with...

My Scenario: I have a fax server that will route faxes to users' email accounts via DTMF. I've read that this can be done with a VMI, but have been unable to come up with any specifics on how to accomplish this. Here's what I have: 300 DIDs - 150 for voice, 150 for fax. MICS 7.0 MultiTech...

I sound a lot like the customer in the above question. I've got a MICS system and have been assigned the task of figuring out how to setup a fax server. The server software will route by DIDs, but I can't figure out what I need on the PBX side to get those DIDs to the server. Can anyone help?