Search results for query: *

Thanks for your help guys all sorted

If they are already in pickup groups you should just be able to dial 66 to pick up the call

Hi I'm hoping someone can help, I have a customer who now requires set extensions to send out selected ddi's instead of the main bearer number on an ISDN30 circuit, I have had a go with some instructions I found online but it didn't work? Does anyone have a document or a precise guide to...

Hi I was wondering if anyone can point me in the right direction, I have a site with a few analogue handsets which are all barred from dialling out, how do I change this to allow outbound? I have tried PGM 601 COS but all jacks say theu are cos1? thanks Joe

Thanks for the help mate much appreciated. J

Hi Can anyone tell me how to send out different ddi numbers on groups of extensions on a pri circuit, ie sales group extensions send out 810010 and marketing group extensions send out 810020 etc. Thanks in advance Joe

Hi I have a customer that has 2 x bri on 2 different bearer numbers. Both worked fine until last week. BRI 1 works fine, but BRI 2 allows outbound but always gives busy on inbound even though the route to a group is there. I have so far Plugged in harrier test phone - phone on the problematic...

Hi Just request a conversion from Dass to ISDN30 they charged my customer about £20 per channel to convert Thanks Joe

The Dass was converted by bt using one of their converter boxes, took about 15 minutes downtime and very cheap for the customer

Hi Mate Thanks for the reply did yours actually get answered? Mine drops as soon as the autoattendant answer so i cant input any digits. Thanks Joe

Hi I have a strange one here, i have an emg80 on an isn30 circuit which has been converted from dass. Everything is fine except for one particular number (their main customer) when they dial the number it rings twice and is then answered by an auto attendant, whereupon the call is dropped with...

Thanks mate is there any other programs that will affect it?

Hi Can anyone point me in the right of programming incoming cli including alpha tagging on analogue lines. I have a cidu card installed, i have turned on cli display in PGM114, what cidu settings and other programming steps will i need to get this up and running? Also will the alpha tagging...

Thanks Ed Worked a treat much appreciated Joe

Hi Can anyone assist me with this i have an EMG80 that requires a different CLI sending out for all stations over ISDN & i also have an IPLDK20 that requires the same, i have ahad a go at both but must be missing a step somwhere as it is not working. Thanks Joe

Thanks mate much appreciated Joe

Hi Can anyone refresh me on the commands to install a new extension card on an ISDX 300? I seem to remember aeq plus slot? then nex to add extension? is this correct and am i missing anything? Thanks in advance Joe

Hi All Is anyone prepared to take a call from me on a couple of strange faults on a isdx? It is too complicated to write out and it would be easier to explain via a phone call. If so please pm your number. Any help greatly appreciated Thanks Joe

Thanks again mate much appreciated

Thanks sbcsu one other question just shelf 0 = the bottom or top shelf? Thanks Joe