Search results for query: *

I tried with and without null modem / modem eliminator. I don't know how to tell if ports are disabled. My aim is to assess the health of the units and confirm memory, port count, etc.

Trying to get an SEB2 (not NetPath) to talk to me via Procomm+. Used both local and host1 interfaces. All baud rates 8-N-1 with and without modem eliminator. Procomm shows connected but no data whatsoever and no response to CR or any other keys. Tried multiple units with no luck. Anyone...

Getting BUG7385 or BUG7388 when trying to boot from floppy....deleted and recopied the diskos to no avail.

Thanks, Firebird. Great site. I copied the zip file to a floppy. Before I start beating my head against the wall (or not), do you know if there is a filename sequence CS1000M wants to see to install or will it search the folders as-is?

Does anyone have disk2921.sys ? Trying to load an old 3.0 for testing IODUC Thanks Brison

F985 = 333 not sure on the number of intercom buttons - would that restrict ability to xfer? previous comment was that the stations in question cannot transfer calls at all and I verified by attempting xfer to receptionist. Sorry for confusion

Stations in question cannot tranfer to any other stations - tested trying to xfer to receptionist. Callers not disconnected, just left with dead air until they hang up. No error given on display.

Good questions - DND was my first thought, but then they wouldn't be able to intercom each other. No error is shown or tone given. When Xfer is initiated from one of the stations to the other, the call disappears. I have not tried xfer from one of the stations to 221, yet. Stations have been in...

7208/7310

We have a customer that cannot transfer calls from stations 226 and 250 to stations 225 and 251. This system was set up long ago - pretty large MICS. The phones are in 2 separate suites. The main receptionist can transfer calls to these stations. These stations can intercom each other. Is...

Can we replace a G700 expansion cabinet without reprogramming the system? Is there a procedure that someone can point me to (assuming it's more than power down and physically replace)?

You are correct - test and status both work. Thank you.

Thanks kyle555. GEDI throws "board" as an invalid entry.

Is there a way to get status on a digital station circuit pack in ASA? I'm remote so I cannot see the indicators on the card.

Prologix - circa 2005. Ideally, we would like to do a simple forward of the attendant console to an Audix extension. Night Service is set up for the trunk group.

Looking to have some, but not all, DIDs on an ISDN/PRI forward to Night Service. Is this possible w/o vectors? Thanks Brison

That explains it. Thanks.

We have a customer with Prologix/Audix. When I list vdn, it throws "vdn" is an invalid entry. Same with Vector. Any idea's why I cannot see or, consequently, build vectors on this system?

OK - all is working properly. Thanks for help. In the interest of best practice, is there a problem with having the same dn entered for prime and assigned dn?

OK - that helps me. I have changed the Received number length to 7 under dialing plan. I've entered the phone number under target line 361 and added set 225 as control, prime and as assigned dn. What I do not see is how to "connect" the target line to my PRI (lines 017-039). PRI is working...