Search results for query: *

We are trying to find the manual to program the phone. I thought there should be a menu in the display for programming

That is the problem we can't program the phone to input the SPID

We have in fact programed the SILC Card for DSL

We just installed a MISP card in our Meridian 81c for ISDN and we just purchased Nortel M5317TDX ISDN Phone. we setup the switch for the MISP programing. I was wondering if anyone can tell me do you have to program the phone and if so how do you do that.

Can anybody tell me if it is possible to do this on a call pilot if not what would I need. I am rying to set up a call pilot to have the auto mattendant answer the call and select from about 500 people in the directory . Once I select a name have it give you a selection of either having it dial...

We have a BCM 400e with call pilot. My questions is with the call pilot is there a keycode you need to activate it or is there other software you need to use thru dialing? IF not how do yopu access the thru dialing?

We know the card is good because it did see at first until we disabled the card then we tryed to enable the module and in the hardware it does not see the card anyb m ore to change it to an E&M Card

Hawks we have gone into hardware and set it up as a E&M Card

First can anyone tell me if thier is a standard procedure for programming E&M cards? The manual is very vague on installing the card. We have a Norstar with MICS 7.1 firmware. In slot 2 we have a 6 port Fibre Expansiobn card and in slot 4 we have a line card installed. In port 6 of the fibre...

The system did come up but we got another issue now. When we go into maintenance and do a module status it shows the following! KSU 1 5 sets KSU 2 1 card mods 3 through 8 are wmpty The setup we have in the system is 1st Module we have the firmware card in it's slot, slot3 we have a 6 port fibre...

We have 2 norstar ICS 4.0 Modules and we tryed upgrading MICS-XC 4.1 firmware to a new 7.1. In both systems and it just wont go into program mode the lights just keep flashing. We thought maybe the firmware was corrupted but got the same symptoms with the new firmware and cartridge, has anybody...

We have a Norstar plus with Modular ICS 4.0. We are having probl;ems with the system when we install the MICS XC firmware 4.1 the system will boot right up go into program mode but when we install the MICS-XC 7.1 firmware the lights only keep flashing and does not go into program mode. I have...

I have verified that thier is dial tone and jumpered to the system and checked the wiring diagram on the amphenol connectors and cheked the resources- telephony 61 for the first line but still does not show up

We have a new BCM 3.7 400. We have gone through the manual and we can see active DN's but the system does not see any co lines. Any help would be greatful