Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Sibell

    XN120 will not Boot

    Well its not dead yet, just not booting up correctly, its powering up ok you said. Perhaps corrupted fw maybe? on the motherboard. What type of flash card (where did you get it?, its not an old dspdb vmail one is it?) Have you got another exifu card you can try? You don't need the LAN obviously...
  2. Sibell

    Group paging NEC phone

    Not sure about this 6-digit code? Your extension phone is a member of a paging group. If this is not required then this can be changed to 0 (member of no group) and disabled from All Calls Paging. This is complete in system programming PRG 31-02 from a PC using PC Pro or via a featurephone. You...
  3. Sibell

    XN120 will not Boot

    Have you checked that the 'NORMAL' switch (bottom-right nr Moh port) is in the correct position? If you have already checked this then try uploading a new firmware version onto the system.
  4. Sibell

    NEC XN120 line group selection

    Well done, next time when you do it using PC Pro you will see how mch easier it is. Well the extensions are hybrid (analogue or digital use for all) so are always going to be a 4-wire circuit, onto patchpanel blues/greens and away on the cat-5. Yes we install the EXIFU comms/apps card into...
  5. Sibell

    NEC XN120 line group selection

    These are very clever little switches with hundreds of features and options, if you are regularly installing these then I strongly suggest you use the PC Pro tool from a laptop to configure the system as some settings will be a nightmare from phone programming. You need the laptop to update...
  6. Sibell

    NEC XN120 line group selection

    Errrm not really sure how to explain it in more detail Yorkie without spending a couple of hours doing screenshots and text expanations as I have given you the program codes for the steps you need to go to, you could read up the features and specifications manual for "loop keys" but I don't...
  7. Sibell

    NEC XN120 line group selection

    Yes this is possible: If using featurephone you can do it very easily by giving them *05 loop/call keys with the keys set to required trunk groups (14-05). Or for the exact scenario (of 8 and 9 access) use the alternate trunk access code 11-09-02 to setup the lines access to the required trunk...
  8. Sibell

    HELP!!!!

    Will be a bit time consuming but what you could do is use Virtual Loopbacks to write a table of pilot numbers to extension numbers. Do a silent renumber of all the extension numbers (i.e. 200-299 to 100-199) then create virtual loopback ddi pilots for 200-299 that point at each new extension...

Part and Inventory Search

Back
Top