Search results for query: *

I have installed a new pri card to our digium 305 pbx. I need help setting up the programming. can anyone assist? will to pay for remote support as well. Thanks

thread940-1715079 The above reference Thread relates to having IP phones in different time zones. Has anyone came up with a way to have different times zones with mix use of IP Verizon handsets using VPN tunnels to different time zones? Thanks

One other thing we notice this morning if boss intercom another ext the system reboots.

sorry about the all CAPS. :) We had two different tech out and neither company has seen it before.

WE HAVE A NEC ELITE WHICH RANDOMLY JUST POWER CYCLE ITSELF FOR ABOUT 20 SECONDS SO IT IS NOT A FULL POWER CYCLE. DOES ANYONE HAVE ANY IDEAS WHAT IS HAPPENING?

Thanks for the replies.... I first thought the same thing but in test the mail box once a voice mail is left in the box it goes directly to the cell phone just the way it is suppose to work. Call in from the cell phone get into the mailbox listen to the voice mail then I push 6 to go to the next...

When listening to a message in the Call Pilot system when I press 4 or 6 to move forward or backwards to existing vm I get the following error. ""the system was unable to reach the number you specify for message notification" Can anyone help with this error?

Finally found v10 on Nortel site. Thanks. If anyone is looking for it go to CICS or MICS. Then search from there.

You must be bored lugerlover. Hopefully you have something helpful to say before posting anything else next time.

I had to format my PC & labtop so I lost my copy of the Norstar ICS Remote Tools software. I notice that Nortel does not allow this be downloaded from their website any longer. Does anyone have a copy (ver 10 or 11) that i can use or know where to locate it. You can e-mail me directly...

I having this same problem. all of a sudden calls are going to peoples mailboxes after 1 ring if someone is on another line. CICS w\CP

How did you fix this? I am having the same problem today.

I guess I having a brain melt down. I need help remembering how to set up a CICS with POTs so that when you pick up the receiver you do not have to press 9 to dial out. It was set up so when you picked up the receiver it grabbed dial tone & you could start dialing immediately. The only thing...

Well guys this is a first I had two flaky station modules. I replace both yesterday. I have never really seen a station module go a fraction bad. Nothing in trouble shooting would have indicated the station module. In trouble shooting yesterday, the only thing in common with the 5 lines were...

From what I can tell the system has not taken a hit. The only thing that is weird is that some of the target line are duplicated to TN's. So I straighten that out so far but no effect on the affected DID's. SBC has double check the translation on the PRI but getting them out with a T-bird...

I have a MICS 4.1 with NAM. System has PRI with DID's riding. out of the 100 DID's about 6 of them ring no answer. I have double checked the Target lines assigned to them under "Lines" & "Terminal & Sets"/line assignment. I am sure I am missing something. System has been running fine for about...