Search results for query: *

Yes that is where I assigned the package. Someone mentioned to me that I may need MCDN for this to work, do you know if that is the case?

I have two PRI connected to a MICS 4.1, and can't route calls out to the central office (PRI-A)from the site to site PRI (PRI-B). Calls go offnet to the CO just fine with routing 9, and calls go between norstars fine with routing dest 8. But trying to send calls from the remote site over...

I am attempting to connect a MICS 4.1 PRI circuit to a Cisco 1760 with T-1 VWIC. The connection is physically good, no errors-slips..etc. I can make calls with Routing Service in the Norstar by dialing "8", and out the PRI (PRI-B), to VOIP phones on the data network. I can make calls from...

Thanks for your response, johnpoole: I have turned off nd2 on the rcap, and trmb to no, I am not certain what you mean " in ld 96 star serv, " ? This system has the DCHI card with the dchannel daughterboard not a MSDL card, does your map dch still pertain. I am seeing that the Nortel Puts...

Thanks here's part let me know if you'd like to see more, just so you know it is an E1 interface REQ: PRT TYPE: RDB CUST 0 ROUT 1 TYPE RDB CUST 00 DMOD ROUT 1 TKTP TIE ESN NO RPA NO CNVT NO SAT NO RCLS EXT DTRK YES BRIP NO DGTP PRI2 ISDN YES MODE PRA IFC ESS5...

I have built a new equipment tie line, with a PRI, IFC type is 5ess, the span and dchannel come up with no errors and calls go into the Option 11 just fine, but cannot dial out. When the trunks/channels come up they are displaying "Idle *" Can someone input why they come up with the * , I can...