Search results for query: *

I have 1500 VOIP sets to build. I cannot remember the steps to get it put into a script. I have a spread sheet built, but will probably need to be tweaked. Any help is appreciated.

The DTRs are all enabled. As far as being in the 1st cabinet, it is 16-1 we have a 4-0 also. This is an existing IPE shelf that went from just 16-0 to having both sides 16-0 and 16-1. I went ahead and configure the tns with a HOT D to override the dialer. Also added EHTA & LDTA to the COS. they...

DTN is set. And checked the node properties.... DTMF tone detection is checked, and Remove DTMF delay is checked. Still have the same problem. Also the loadware was all updated as of early April.

We have a few elevator phones (autodialers), and some regular telephones(home phone) that do not break dialtone. We have no problem on fax machines, or on our test sets. This system just got upgraded to the new 7.5 with 1010 cabinet. Also we upgraded to the MG XPEC contollers on the IPE shelves...

I am familiar with that cable, but was told there is somthing different for the 200 I.

We are having to install an old 200i on an 11C cabinet. I have some 201i cables (NTRH09) I think that is the part number. Will this work on a 200I? I cant find a manual anywhere. I have read that there is a box the size of an ATA that has to be used. Any help will be appreciated.

Okay just thought I would check. Thank you very much!

We have a call Pilot 200i (old)1.7 software. We have been told to replace the old 200i card with a new (refurb) 200i card since the SCSI connector/port does not work anymore. We have tested all the equipment and this is going to be our fix. My question is, once I get the new card can I just take...

Okay, I have been testing the ESA. You have to have MTC on the TTY. (which I did.) I ended up removing the ESA block and rebuilding it, and it started working. I'm not sure why!!! All I can say is "That's Nortel

REQ PRT TYPE ADAN TTY ADAN TTY 0 TTY_TYPE SDI CAB 00 CARD 00 PORT 0 DES MAINT_TERM FLOW NO USER MTC SCH BUG TTYLOG 0 BANR YES ADAN TTY 1 TTY_TYPE SDI CAB 00 CARD 00 PORT 1 DES SEB BPS 9600 BITL 8 STOP 1 PARY NONE FLOW NO USER MTC TRF SCH...

REQ PRT TYPE ESA CUST 0 CUST 0 ESDN 911 ESRT 0 DDGT 911 DFCL 7703395963 OSDN 3395963 MEM AVAIL: (U/P): 2476152 USED U P: 534853 85570 TOT: 3096575 DISK RECS AVAIL: 1152 What else do you need?

I used to have the 911 calls setup to notify the tty ports and an OSN key on 3904 set. I was told the other day that outr security phone is not being notified of this. I made some test calls and verified that I am not getting the info on the maint term, or the tty i dial into. It is also not in...