Search results for query: *

Station has enhanced call forwarding active forwarding to a cell phone. When called from an internal number it will forward the call, when someone calls from a cell phone to the station it does not forward the call. The call trace on the station shows it is forwarding the call but says term...

Callpilot 4.0 1002rp is not answering when dialing the main number. Checked the MGATE cards and channels on the server and everything looks fine. Restarted Blue Call Router and Call Channel Router services, which didn't help either. Flashed the DSP's as well which didn't work. I'm out of ideas...

I did replace the card.

A few weeks ago my CS1000M lost power. When came back up everything appeared to be working fine until I started getting complaints that caller id was not working on CLASS phones. Some searching I discovered that both XCMC's were disabled; I went to enable them but would get NPR326. I disabled...

yes and the class of service as well. It's all phones not just specific ones.

yes it is and we tried that FFC also with no luck.

Did an INI yesterday and it didn't help. Any other ideas or suggestions are appreciated.

unfortunatley no, on seperate networks.

in the RDR_DATA options are CFF CFRD DSTD PVCD CWRA MCI

That's correct, works for everything else just not call forwarding.

We don't use ICFA because we have networked PBX's and CFWA allows you to forward calls to another PBX if needed.

just stopped, customer called complaining about it today, so we're not sure for how long it hasn't been working. When we went to test it, that's when we noticed all of our phones are having the same problem. Traced the call to see what digits were being dialed and it showed the FFC as the dial...

Yes call forwarding is allowed on the set, and yes it is affecting all sets.

I have a CS1000 Release 5. When the FFC to activate call forwarding is dialed, I get an imediate fast busy after the last digit of the code is dialed. Example: dial *72 get a fast busy after the 2. Tried using alternate code, but did not work. Other FFC's work just fine, so not sure where to...

Thanks for all the answers!

How do you flash firmware?

What about CISCO IP Phones, can they be used on a nortel switch? Does the Signaling Server care?

We have CS1000 release 5; wanted to know what IP Phones we can use?

Call Pilot 1002rp Server running release 4.0. Multiple mailboxes are being disabled, and when it is checked to see if there were invalid login attempts there are none. Anyone know why or have the same problem?

I was just wondering if there is a number assigned to a T1 for billing purposes, if not how is the billing done for T1's? I have a meridian 1 opt 81c.