I don't think this is your problem! I have a photogallery on my website (www.rotacrony.com/Rota.htm) that has 129 photos with descriptions without problems of any kind. I was using FP2002, but now have FP2003 and no problems with either version of FP.
Hello bcaster,
Well I ran FDISK/MBR and all that happened when I rebooted was that WIn XP reported new hardware found. However, I still have the "divide error" when booting with a MS-DOS Startup disk and running my Partition Recovery Software to do a backup on the MBR.
I might add...
Hello bcaster,
If my system boots up into Windows XP correctly and there is only one partition on that drive, would this be possible with a missing or corrupted MBR. Also what happens to the existing MBR if I run FDISK/MBR?
Thanks for the input.
Bill
Not knowing where you i'll say good evening CoBolKid,
Thanks for the reply, but this isn't what's happening here. I have already tried everything you mentioned prior to requesting help. I'm not a computer expert, but I did work at an Information Systems Department in a military hospital for...
Hello CoBo Kid, actually I did not exactly frame my problem correctly as I look at it again. The 'Divide error' I receive only occurs when I boot the system using an MS-DOS system disk. I boot this way in order to run my Partition Recovery Application, which is a DOS application. The system...
I deleted primary partition 'C' drive (number 1 physical drive) and with accidentally all partitions on 2nd physical drive. The lost partitions on the number 2 drive were restored using software from "Active Data Recovery Software". OK so far, however from this point on when booting...
Hello All,
A very big hearty "Thank you" to all who responded to my plea for help and especially you, Mark. I connected my cable modem via the LAN cable vise USB port and have been surfing the web for about 5 hours with no problems (my eyes are crossed [;->).
I can't believe my...
Hello All,
Concerning the RAM, I have installed 2 cards of:
Corsair XMS Extreme Memory 512MB PC3200 DDR400 MHz. I might add that during the past week of trying to set this computer up, on two occasions I received 3 rapid beeps on POST but each time the system continued to boot. Yesterday I...
Hekko one more time,
I just finished Using MemTest 86 v3.0 and my DDR400 RAM passed all test with 3 passes and no errors. So I would hope this eliminate bad RAM from the list of suspects in this problem {:/
Hello again,
I should also have included that in addition to the IRQL_NOT_LESS_OR_EQUAL errors I have gotten lots of BugCode_USB_Driver errors with the following data 0x000000FE (0x00000004, 0x857814C0, 0x8558E538, 0x00000000) and a few Bad_Pool_Caller errors. As I don't have ready access to...
Hello, I'm building a new system and with Intel D875PBZ motherboard, Intel P4 3.05GB 533, DDR400 1.024MB RAM, Maxtor 6Y080L0/6Y120P0 drives and Thermaltake Xaser 1420 case, ATI9500 128MB video card, Creative Soundblaster 5.1, 3COM EtherLink 3C905-TX NIC, Philips DVDRW1208, Sony CD-ROM CDU5211...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.