Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. branchcom

    NEAX 2000 8DLCP

    Thanks everyone for the replies, and suggestions. I'm going to try and get a replacement CPU to rule out the backplane issue. I've looked at the area around the KSU, and there are no leaks or moisture. What is the best way to back up the database, in order to restore it to the new CPU. Also I...
  2. branchcom

    NEAX 2000 8DLCP

    I just left the Nursing Home. I removed all the other cards, and the card in LT05 is still not working. If I busy out the extensions in programming, all the LEDs will flash, but when I put the extensions back in service, the lights on the card go out, but the phones still do not work. Any help...
  3. branchcom

    NEAX 2000 8DLCP

    Unfortunately I didn't get a chance to go back out today. However there is a voicemail card in LT00, 8-DLCP in slots LT01-LT03, 8LCAA in slot LT04, and the card that isn't working is in LT05. All extensions work except the extensions LEN 040-047. As I said earlier, the phones just died. I'm not...
  4. branchcom

    NEAX 2000 8DLCP

    I'll try that and get back to you. Thanks
  5. branchcom

    NEAX 2000 8DLCP

    I also removed and checked the tail. Then put it back. Also this is not a newly added card. The maintenance man said his phone display was dim, then his phone just died. I swapped the card with a card that was working, and the problem did not move. I replaced the card anyway, because I had a spare.
  6. branchcom

    NEAX 2000 8DLCP

    There are no lights on the card at all. If I CCC each extension, or make them all busy, all LEDs will light on the card.
  7. branchcom

    NEAX 2000 8DLCP

    All extensions on this card are dead. All programming looks OK. Replaced the card but the extensions are still dead. Any Ideas?
  8. branchcom

    Target Line problem w XC 4.1

    I've assigned the received digits to different target lines and have had no problems. I've taken lower numbered received digits that are currently working and assigned them to the higher numbered target lines,and they have failed. I would like to re-install the PRI but I don't have the...
  9. branchcom

    Target Line problem w XC 4.1

    Yes I did a system restart. I didn't actually power the system down though. Thanks
  10. branchcom

    Target Line problem w XC 4.1

    Thanks for your response. The card does have XC 4.1 SW on it,and if I'm not mistaken,you can't even attempt to program a target line above 275 if it isn't XC. I may have to initialize the database and start from scratch. Any suggestions will be appreciated.
  11. branchcom

    Target Line problem w XC 4.1

    I'm having trouble w/ Target Lines 273-336. I have XC 4.1 software, but when the received number is programmed and the prime set is designated to the ext. I need to ring, I get one quick burst ring at the set, and a telco error message as the caller. However,if I do not program the received...

Part and Inventory Search

Back
Top