at work we have multiple subnets, 1 for head office and then each branch office location have their own
e.g. head office 193.0.0.0/24
branch1 193.1.0.0/24
branch2 193.2.0.0/24
etc...
193.0.0.1, 193.1.0.1, 193.2.0.1 are routers
so the first IP of each subnet is used for their routers
noe i...
i have a sonicwall TZ170 and have a cable from its lan ports connected to a pc, the pc picks up dhcp from the sonicwall 10.0.0.1, (PC =10.0.0.101)
but when i try to use web browser to open http://10.0.0.1/ to config the sonicwall box the browser just says page cannot be displayed
any ideas
ive' started the fw and svn thru voyager
then went into console -hyperterminal
and ran cpconfig
now the thing is i have registered the nokia box on their site but how do i get or retrieve a licence for the checkpoint,
should it not be on it already
the bag i got with it (docs/cds) didnt have...
ok i 'll try that later this evening, btw i did try the console conx where it boots into Bootmgr , logged in and typed cpconfig but just got a invalid command.
seemed like something .or service wasnt running maybe?
ok so now setup is as:
adsl router (10.10.0.1/24) ----> nokiaip CP/FW (10.10.0.254/24 eth1)
router has 10.10.0.254 set as dmz host (i had that previously for the isa box to NAT
eth2 10.20.0.254 firewall
pc prometheus/10.20.0.30 (static)
now i think i need to start the CP and config it...
thanks , i'l all this later this evening when i get a chance
q4 : WIFI
assuming i use 10.30.0.250 for eth3, should i set a static ip on the WAP (10.30.0.251)and then config the wifi clients with static 10.30.0.10-20 ips and mask 255.255.255.0, gateway 10.30.0.250 (WAP)
ok so then assuming...
Q2/A2: ok so I should make eth1 the 192.168.0.250 and set its default route to 192.168.0.1
Q3/A3: i take it cpconfig is run in a serial console conx
or is there a voyager page to config gui client connections
Q4/A4: I think i explained the wifi scenario wrong
what i was trying to say is ...
Q1:does that book show everything from start to finish on how to setup a nokiaip box with checkpoint?
the scenario i want to setup is:
eth1 - 10.10.1.250 ----> Dual Speed Ethernet Hub ---> LAN (10.10.1.0/8)
eth 2 - - 192.168.0.250(static) ----> ADSL Router (DLINK) (192.168.0.1/24) , DHCP is...
hi i have a nokia ip350/380 firewall
i nered some help getting it set up i have little or no docs/sw as i got it second hand
i got a copy of the checkpoint management clients
(\fw41_sp3_w32_gui)
i basically need to get the initial setup of say the first eth1 to a lan ip, i think
i hav...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.