Jeter, thanks for the link I have read it a couple times now and the following note pulled from that article. Leads me to believe I do not have to update the IOS.
Note: The bandwidth remaining percent command was introduced in Cisco IOS version 12.2(T).
However, when I enter the commands it...
I tried adding the bandwidth command to the serial interface but this did not help.
So, I guess my question should be how to assign the bandwidth command to either the interface or policy in order to enter the priority percent command.
Thanks,
John C.
Cisco 2621xm
IOS: 12.2(28c)
Hello, I was tasked with replacing a managed router in order to save a couple bucks. I also received to my surprise a fairly good amount of information from my ISP to complete the task.
However, I am having difficulty with a few commands but most importantly the...
Oops! forgot to mention we currently have three terminal servers in production and this is our development server. I would like to install apps on the development server and document the procedure. This way the process will have been thoroughly tested prior to placing addtnl terminal servers in...
I am familiar with 2003 server for the most part but not so much with terminal services. We recently acquired a development server to test prior to making changes in our production environment.
I would also like to document the installation procedure for this new server to apply to new...
Supergrrover, thank you for that piece of information. I misunderstood completely how the ACL would behave when making changes on the fly.
baddos, thank you as well for the line# piece this will help greatly when adding deny statements.
Also, I waited until after hours to apply the changes...
Hi, we are currently using a Pix515 and have the following ACL configured. I would like to add .47 remotely but have not had much luck with this in the past. What I mean is modifying the ACL on the fly will cause me to lose connection to the pix. Should I add just this one line or paste the...
I believe these are the codecs which will be used for the scenarios you mentioned. At least that is the way I know it to work on my SIP PBX using SIP phones but I am not certain.
1. G711a
2. G729
3. G729
4. G729
John C.
Sounds like a routing issue to me. Typically, when you have a one sided conversation like this it is because the remote phone can route to the media gateway but the media gateway cannot respond or send voice back in your direction due to either a missing or misconfigured route.
John C.
Hi All,
I am not familiar with polycom phones and just configured one. I got it registered using a basic config and can make both inbound and outbound calls. However, when I am on a call and a second call comes in. If I press the "End Call" button it disconnects both the call I am on and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.