Hi.. sorry to snoop around.. but could i ask..
im not well experienced with CALs.. just did one before.. anyways which is safe to configure.. a Per Server or Per Device or User.. i know answer for this question depends on your network structure.. but what if the situation is like this..
For...
Hi.. need help in explainin the following.. what does this counters mean.. 1. bad hop 2. encapsulation failed 3. no route 4. not a gateway
Router1#sh ip tra
IP statistics:
Rcvd: 6947190 total, 151408 local destination
0 format errors, 0 checksum errors, 804 bad hop count
0...
BTW i'm using cisco 1600 which has a eth of 10Mbps/Half ONLY..
i tried changing to full duplex.. but it wont allow me =(
if you're givin me an option to buy new stuff.. i can't.. because someone's hindering me.. i hope you know what i mean =)
is this the only solution.. to make all...
Thanks..
after some numerous changes, it went good but not yet accecptable.. because now i'm getting increasing defferred counts..
what i did was i changed my routing..
before it was ip route 0.0.0.0 0.0.0.0 10.0.0.2
now i made it to ip route 10.0.2.0 255.255.255.240 10.0.0.2
now my PCs can...
Thanks, Sir! (IPKONFIG)
But I just found out something else.. i tested it yesterday.. and i still need all your help, please.. both routers A and B are fine.. no hardware defects.. the scenario is like this..
internal Lan --->Switch (3com) ---> RouterA (cisco 1601)
my internal LAN consists of...
Jan.30
Hi.. i'm just a newbie with routers.. so please help me..
I have 2 cisco 1601 connected back to back.. one DCE and the other DTE. encap is HDLC. clockrate on the DCE is 64000.
Both routers have Serial is up and Line protocol is up.
From router A (DCE), I cound ping router B (DTE) but...
routing is enabled.
-----------------------------------------------------------
Current configuration:
!
version 11.1
service config
service udp-small-servers
service tcp-small-servers
!
hostname Router A
!
enable secret
enable password
!
ip subnet-zero
no ip domain-lookup
!
interface...
Thank you.. all subnets are 255.255.255.0..
yes my PC is configured a 10.0.1.1 gateway..
I am inside the routerA.. in Telnet.. or even in HyperTerminal.. i still couldn't ping serial A..
do i have to configure a static route from eth0 to se0?
Hi?! i'm just a newbie.. pls be kind to me =)
my network looks like this.. encap is HDLC
router A 10.0.1.1eth0 <> 10.0.0.1se0 <--csu/dsu--><--csu/dsu--> 10.0.0.2se1 <> 10.0.2.1eth1 router B
my PC is 10.0.1.2 ..i telnet 10.0.1.1eth0 ..from inside, i tried to ping my se0 10.0.0.1 ..i got a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.