Probably because the LinkSys is running NAT.
Try plugging the e0 to the INTERNAL side of the LynkSys, thereby only using the Switch. Of course, if you don't have DHCP set on the Cisco, you'd need to assign the 10.xx.xx.xx addresses to the computers. You'd also have to change the default route...
I think you would need to expire the DHCP lease.
The lease is specific for the MAC address.
Otherwise; you could from an enabled state:
UBR7200# clear cable host <MAC ADDRESS of computer>
UBR7200# clear cable modem <MAC ADDRESS of MODEM> reset
This is, of course, after you have found the MAC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.