Hi,
I was wondering, does there exist a Perl code generator?
More specifically for the following :
a tool where you can setup your connection with a ODBC database, design a webform, write a select, update, create or delete query
and then generate a basic html page, and the .pl file which goes...
Hi,
it happened a few times now that I had to recover from a corrupt regsitry in XP
this means one or more of the files in :
c:\windows\system32\config were corrupt :
c:\windows\system32\config\system
c:\windows\system32\config\software
c:\windows\system32\config\sam...
Hi,
I just want to point out ofr your benefit that :
- winroute is an actual NAT router & firewall
- wingate and winproxy are more "connection sharing" tools (with not much security)
- with the new winroute 5, configuring as become a lot easyer (and it does allow MSN messenger...
I'm evaluating Winroute 5, and have following issue :
although I've 2 rules, allowing http traffic (on port 8080) from the firewall and fro mthe internal lan
(the standard rules after the wizard)
when I start my browser on the firewall, with the required proxy settings, I immediately get an...
Hi,
you might want to check your packet rules,
if your firewall is closed thight, you may need to allow dhcp traffic (dynamic ip addressing) on your interface to the cablemodem
on your "wan" interface, add a rule :
"udp any host port 67 -> any host port 68
port 67 is the dhcp...
Hi,
I have the same problem, on a regular base,
but I don't think this is due to anything with your configuration
the hotmail support in outlook express is kind of a beta from Microsoft and often fails (there is also no support for it from microsoft)
Sometimes it does not work for 2 or 3...
Hi,
your 1st question :
normally you should be needing portmapping in that case
your 2nd question :
below in your taskbar (at your clock) you should see a blue round icon, if you click with your right mousebutton, you can "disable" the winroute engine, then the firewall just stops...
If there is no ios present or the flash has been erased,
your router will bot into the "rommon>" prompt.
if your flash memory is valid (not corrupt or bad chips) you can load a new IOS using xmodem (cfr. below for the procedure)
http://www.cisco.com/warp/public/701/59.html#rommon
I...
Hi,
There is a tool called "Cisco Configurator"
which is freely available for download at the Cisco CCO site.
http://www.cisco.com/cgi-bin/tablebuild.pl/configmaker
It is a GUI, and contains a network configuration wizard for routers.
Kindest Regards
Olivier Ceuppens
NetCom...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.