Thank you again, really appreciate all of the input. Finally got it WORKING!!! What I did was so simple. I simple made sure both tty1a & tty1A disabled, shutdown, removed the card. Booted up, again made sure that they stayed disabled eventhough no card. Shutdown, put card in & booted up. Then...
Thank you, but when we installed the 3rd board & made sure the Jumpers were correct I got the following: Warning: Serial garbage loose cable on dev 0 port shutdown then
init: command is responding to rapidly check for possible errors
id Se1a "/etc/getty tty1a m"
checked the settings...
tty1a is not responding to our attempts to dial out. port disabled, modem was checked & is okay, there was a lock on tty1a, which I removed. Our vendor thought that our serial board was bad, so we replaced with a WinBond 85757F, still same problem. Currently, we are putting to old board back...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.