Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
How to keep track of remote Cameras IPs from my site?
Visit www.dynsdns.org This is one of many sites that handles dynamic IP's. You set your router (or device such as "slingBox") to contact that site if the IP is changed (this is a built in function of routers an/or some devices). When a device behind a firewall sends out a new request to... -
form send to top
Should have stated; See the third posting for correct syntax- Whalco
- Post #3
- Forum: Visual Basic (Classic)
-
form send to top
check out http://www.vbwm.com/forums/topic.asp?TOPIC_ID=3997- Whalco
- Post #2
- Forum: Visual Basic (Classic)
-
Lost component references
You might want to checkout thread 708-387563 particularly if these controls are 3D. The last few comments were particularly useful to me. http://www.tek-tips.com/viewthread.cfm?spid=708&newpid=708&sqid=387563- Whalco
- Post #6
- Forum: Visual Basic (Classic)
-
installing ports??
in the start menu <RUN> regedit. Careful when using this to change settings!! Under EDIT\FIND try searching for 'COM3'. The search is case sensitive. If com 3 was used previously, and was not unloaded properly when the board was removed, parts of the old install may still remain, and the...- Whalco
- Post #6
- Forum: PC hardware - General discussion
-
Control Arrays
Dim X as integer for X = 0 to <MaxNumber of Array> Control(X) --perform action-- Next replace <MaxNumber of Array> with the appropriate number or variable. This assumes of course that your controls are indexed from 0 to <MaxNumber of Array>. hope this helps Al- Whalco
- Post #2
- Forum: Visual Basic (Classic)
