Search results for query: *

Thanks, Yes, I got picked up on the command thing on Friday night ! Thanks for the code above, I'll give it a try. We just have one legacy inhouse application on the mainframe that will get to the hp's but not do landscape, we just need to get the code in there ! We have most other things...

Hi All, Would someone be able to help me with 2 postscript commands. I need to know the commands to make a page landscape and the command to make it portrait. We have some Mainframe based applications that used to go through good old controllers to good old Xerox printers, but we are...

debugging is good as long as the routers not too busy, debug isdn events and also isdn q921/q931 and you should be able to see at least some info from the telco,,

Well, there are tx transmit packets, but no rx receive, do you have access to the Adtran box ? I'm not familiar with them but had a quick google and they seem to have some setting switches and also in the troubleshooting they mention some leds for fault diagnoses, if the telco reckons the lines...

Hi Jeff, Try doing some isdn debugging, carefull when you debug though if it's a busy router ! debug isdn ? events ISDN events q921 ISDN Q921 packets q931 ISDN Q931 packets Here in Australia we get some rx packets on either q921 or q931 at regular intervals if the isdn...

Hi All, I realise the 4517 is an old model now (introduced 1996), but does anyone here still use them and if so understand the memory in these things. I've been playing with 16meg simms today and the printer has 2meg onboard, but I always end up with 22meg according to the config sheet...

Hi, Thanks for the replies, we finally discovered that the modems have 2 ports one marked line and one marked phone, when installed by the staff in the small branches, some chose phone ! We need to tape over so they can only use line !!! Steve.

Thanks EB, Here's most of what's in the conf for the aux port: autobaud login modem Dialin transport input all flowcontrol hardware The thing is, the modem will work when we test it on routers with us, it is of course only when we send it out that it mis-behaves ! We use mostly...

Hi all, We have several 1700 series routers out in small branches and seem to be having problems with a few on the modem connection via the AUX port. Sometimes it will connect but not go through to the router prompt, CONNECT 31200 So even if you hit enter a few times, it...

I usually use the web interface, it's faster, else you have to create a file like: conf t int faste0/1 spanning-tree portfast exit int faste0/2 etc etc etc And cut and paste it on the switch, So it's easier to go via the web !!!!

Thanks Thomas, Yeah, the message is pretty much as follows: jobname: error: undefined offending command: file: %-12345@PJL EOJ It prints that at the top of a page after every print and wastes a page ! I'll have to check through all the options, it seems to not hold all it's config when power...

Hi, The manuals should be on the IBM web site, a 130 error is either the diskette or the diskette drive, we normally pull the floppy out and blow the dust out of the drive and the disk and chuck the floppy back in, shut the gate and re-iml. Good luck ! Steve.

Hi, Anyone out there using the Phasers ? I have a new one installed at work and I'm getting an undefined error page print after every print on through the ethernet card. It has %-12345@PJL EOJ on the page. This error page has come and gone previously, I had power cycled the printer when it...

Maybe try different speeds, sometimes they are changed to speed up recoveries. maybe 19200, 38400, 57600 or 115200. If you don't know the history, it might have had an upgrade problem ! Steve.

Hi again, i've registered now, I meant being able to get into the cisco router via the vulnerability, not the site listed ! Sorry about that !!