Below are route, COT and Set parameters
***************************************
****** ROUTE DATA BLOCK ***************
***************************************
CUST 00
DMOD
ROUT 0
DES GENERAL
TKTP COT
NPID_TBL_NUM 0
PRIV NO
RPA NO
SAT NO
RCLS EXT
DTRK NO
ISDN NO
PTYP ACO
AUTO YES
ACMP NO...
contrary to what I reported earlier,
FEDC is set to ORG. We had tried setting it to ETH however this seemed to increase the problem. I tried it again recently (definition of insanity?) with the same result.
Thanks for the replies guys.
I confirm that we have no issue with Tip and Ring (to the best of my knowledge. I sorted that out with the telco about three weeks ago. I also tested all of the lines for ground start by using a test set at the Demarc.
My digital sets and auto attendant dont seem...
FEDC and NEDC both set to ETH but I still see the problem.
You have any lead on the LDTA cls ? I have not set it as yet
I'll post the RDB print and a sample COT print if that would help.
Andre
Have a site where we have recently deployed a Callpilot Mini to an Option 11C Rls 25.40. We found that we had to go order ground start trunks from the telco for disconnect supervision. a problem still remains though.
We have programmed the trunks as TKTP GRD and set SUPN to YES. The Option...
you can also use enhanced trace in LD 80 i.e.
entc c u xxxx
where c u is the TN (on an option 11) and xxxx is the time you want the trace command to run.
after that you must start the trace by entering the command
gotr
This is a good alternative to trac and trak when you need a realtime...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.