You need to make sure that all trunk routes used in the connection of this call have the appropriate settings for the answer signal that may or may not be sent to or expected by the originating trunk route. These parameters are normally set in the SIG parameter of the ROCAI command and there are...
I too have regular hard drive problems, although we DO have 3.6 as an image. I am struggling to find a really good imaging package either Linux or Windoze, I am constantly rebuilding primary drives to rescue Customer data :( current drive is Maxtor 20gb but going over to 80gb Maxtor as 20's are...
Can anybody help me out with an issue on the redundant drives on a BCM400 failing.
I have had 2 sites so far that the 2nd drive failed, according to the alarm log anyway.
1/ Is there an issue with the Early raid controllers (model not handy) and/or the drives.
2/ Am I able to put in any type of...
Thanks for all assistance provided. Reason for asking is that networking problems are sometimes investigated in lab environment with customers data loaded and of course the licence is needed. Ability to change licence as needed makes life easier for me. NIU is not a problem for me, only the...
Has anybody out there had any experience with erasing the EIC from an NIU2? Is this code held in a specific chip on the NIU2 and if so which chip (location, type, etc)? Any help would be appreciated.
Regards
Lifer
But, it worked in the lab!!
I thought the 1st rls to fully support the 39xx handsets was 25.30.
24.xx = No Go, handset worked but no features past line key and hold. It looked like a 2006 or 2008 with no softkeys. :(
25.10 = uummm, the less spoken about that rls the better, lol
25.30 = now old but it had firmware...
I am on the hunt again, :) is anybody able to give me the specs or part codes or both for the ram used on the LPU5 to suit BC12.
I know it has to be 2 x 32meg sticks.
I have tried many differnet combinations on 4 different cards of various firmware (R8A-R10C) but no luck, on boot-up I get the...
Hello you techies out there!
I am on the scrounge again :)
I need the schematic or circuit diagram for an MFC INDIAL TESTER. I have a couple of techs here that need to be able to test MFC indial circuts by way of introducing MFC/DTMF into the pipe & apparently they tell me that such an animal...
How long do you wait for xfer to latch? It sounds like a 'b'end answer problem, the 'b'end does not acc or has not yet acc'ed the 'a'end that the call has been answered.
Janaya, I can remember a network of option 11c's with the same problem. It turned out that the CDR record is working correctly because the call from 6470 is an outgoing call from the BCM through the 81 so it is a transit call (trunk to trunk). The BCM CDR record should show the outgoing call...
Hey ppl,
I am having trouble finding a manual, either user or install for the Panasonic KXT3281AL 2line handsets.
I have to maintain about 40 installed units across a large state in Aus and really need to get some documentation for my techs. Any info regarding the programming or even user ops...
Have you checked the designation of the originating tie call, usually a tieline call is set as internal not external incoming to the 81. Internal CDR is off by default.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.