Sorry, wrong terminology for 7. Zero Wireless Config is actually WLAN Autoconfig. As before if you are running a third party softwareware to monitor and configure your Wireless connectivity I'd turn it off completely and allow Windows 7 to handle the wifi features. This at least rules out the...
Not sure if you've tried this yet but have you tried using Windows Zero Wireless Configuration only to bypass any vendor wireless utilities issues? Some vendor wireless configuration software can mask problems.
To test further try this. Disable IPv6 and put your connection information in statically for IPv4. Then see if you can communicate correctly between all devices.
Please review: http://tek-tips.com/viewthread.cfm?qid=1504786&page=1
January has been spent in the data closet moving from Netgear to Cisco and sorting out a wiring nightmare.
On this network the short overview is this:
Three subnets used:
172.20.1.x
192.168.112.x
128.1.27.x
All IP...
There is simply not enough time or space to enter all the data of what has been attempted here to get through this problem.
Good news is in all the swapping out of wires and rearranging cables the duplicate problem which is the original problem has now been resolved. Depending on which of the...
First I want to thank each of you for attempting to help me out here with this. Just know as we move on here this network (these errors) were already in place on my arrival certainly they were not part of my design.
To add some highlites here:
Question:
Do all of your switches have spanning...
Ok, The duplicates devices are gone I'm seeing neighbors as one again. Replaced 80% of the cables in at the MDF and corrected a few connections as well. One of these worked at least for the duplicated device issue. There is a part two to this story and it is that the network has been dropping...
I've checked for loops and none existed. However there remains some cable work that needs completed. Once this work is completed then if the problem persists more information will be added.
Unfortunately the switches are all unmanaged Netgear 524 devices. However the fact that cables may be looped could be the problem. There had been some cable management performed about a month ago and this would be close to the time this problem began to show up. Today the cable arrangement will...
Equipment:
Cisco 3600 series router
Symptom:
Execute the show cdp neighbor commands and there are two of each neighbor showing on two seperate interfaces.
Analysis:
Incorrect route
Problem:
Routes in the 3600 appears correct.
Question:
Has anyone on Tek-Tips Forums experienced this problem also?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.