Search results for query: *

Hi, Sounds like good advice. Actually, the first thing I did was make an image(not sector-by-sector as most of the disk is empty) with Acronis. I thought that way if I mucked it up, I could just reimage the one drive and then recreate the array. Thanks!

Hi all, I dug some more and found something odd. When I booted up last time and went into the RAID fast-build utility provided with the AMD chipset, I selected option 4 which was to view the controller configuration. It indicated it was on IRQ11, and said ‘AHCI HBA MMIO Base Address FE02F000’...

Also - FYI, per Belarc, Disk 0 is my C drive and Disk 1 is now the F drive. Both show up as healthy and active in Disk Mgmt. It is like the RAID array 'unlinked'. I had no warnings at all of any impending drive failure, so I am wondering if it actually failed or if there is a way to relink them...

Hi, I think I need an expert here. I have a SATA 2x 640GB RAID1 on my PC and it has been working fine for a couple of years. Suddenly now I am getting a critical error on boot and when I open the RAID facility and look at the LD it shows 2 disks - one as JBOD on LD 1-1, and the other as critical...

Hi, I have done some research on this and know that the built-in Fast Eth port on the 2620s handles dot1q. Does anyone know if the NM-1FE-TX add-in cards will support dot1Q? Is it solely dependent on the IOS ver, or do they not support it at all on any routers less than 3600 series? Thanks!

I have three computers connected to a switch, Cat 5, RJ-45. Two Win98's and a Win ME. All 3 have a specified unique IP address, the same workgroup name, and the same subnet mask. Win98 machine 1 can map a drive using the computer and share name to both computers. Win ME machine can map a drive...