Search results for query: *

Yeah, Just to advise you guys if you happen to run into this. I used a Lexar 4 GB Thumb Drive, formatted into a 2GB partition with the Linux Install Files. I then had to play with the BIOS for the Hard Drive to change it from AHCI, to IDE LEGACY, then back to AHCI and the installs worked fine...

Its a function of the TTY Ports, as it could very well be that Multi-User Login is not supported or not configured properly within either the Configuration 1 (ld 17) or within the TTY port specifically. Hope this helps

I strongly believe that to login directly into the Root Account after a 5.5 install, it may be disabled, as I know in the later releases that this is the case, and you typically either need to use the Nortel or UCM Admin account. However, as you mentioned you are able to SU, so it did take the...

Haha; Yeah. This information would be stored on the Communication Server in which your Telco team would have access to at your internal department. Your best bet is asking as mentioned above, directly from your telco team, a printout of your TN and DN. Hope this helps.

Well, got past this part, now having issues with asking for where I would like to install the 7.5 Applications from. Keeping you posted.... ...Wouldn't mind if someone would be able to also assist. Thanks,

Hey all, Managed to get a bit farther; please see the output in the attached file from me trying to get it installed. Now its giving an error: Unsupported hard drive configuration has been detected on this server. Please follow the NTP documentation for the correct configuration...

The USB is plugged in, and its noticed but it doesn't want to properly install the media.. Thanks,

Hey Chrisay, Thats exactly what im trying to do via the Linux Base via the Front of the USB. Thanks, Josh Lapointe

Hey, Or even better for patching and version levels: LD 143 MDP ISSP That will show you patches and sw/version installed. From there we should be able to give you a hand further.

I personally at my company use a Nortel (not Avaya) VPN Solution, and have the 4.0 Version of the Softphone running and it seems to run perfectly fine on my Windows 7 32-bit client. Have you attempted to use the new release of the Softphone, cause I know anything past 3 you are required to have...

To properly get into a 7.0 Switch, you will need to use SSH, which will ask for the RSA token verification, from there, you can login to the Linux Base (if co-res) or directly to the VxWorks. If you are running linux, then just issue command cslogin to get into the Call Server. From 6.0+...

Hey all, Quick Question. I have a MG 1000 Chassis and currently trying to get a CP MG installed; Here's the issue i'm facing. Its a brand new CP MG Card, so I connected to the back using the R232 adapter to install the MGC portion, which I created the ELAN IP addresses and pointing it to the...

Damn, this is what I was hoping it wasn't. We had recently replaced a power supply within the last 6 months in this very same unit. You wouldn't happen to have that doc located someplace or can point me in the right direction to find it? Thanks again for your help,

Hey all, I'm relatively new to the forum and would like to know if you guys would be able to assist with a delema I am having with my Call Pilot system. During startup (after plugging in the system to power, the system starts to boot up, however it gives a boot light sequence, and nothing comes...