Search results for query: *

I currently have a stack of 3750 switches. All have the same advancedipservices IOS. I want to add a couple of new 3750Xs. The new 3750Xs have an IOS with 'universal' in the name. From what I understand, the 'universal' IOS image contains all of the feature sets, but only the feature sets of the...

That did it. Thank you very much ISPKing!

This is what I get from a sho ip redirects: Default gateway is 10.2.2.6 Host Gateway Last Use Total Uses Interface 10.101.1.51 10.2.2.1 0:00 293949 Vlan1 10.255.254.223 10.2.2.1 0:00 318697 Vlan1 What can I do to...

When I do a show run I don't see any line that has 10.101.1.51 in it. Any suggestions on where else to look?

ISPKing, What do you mean check the interface assignments?

It is definitely using those two other routes. I just don't now where it gets the routes from. I'm sure it's statically defined, I just don't know where.

I have a Cisco WS-C3750-24TS switch that has some routes in it but I can't figure out where the routes came from. This is the output from a show ip route: switch2#show ip route Default gateway is 10.2.2.6 Host Gateway Last Use Total Uses Interface 10.101.1.51...

You can do whatever you choose with the ports. They're just ethernet ports.

Try this one: http://www.ncomtech.com/trapgen.html

Bump. So here's what got it to work. I removed all of the snmp-server commands and then only entered these commands: snmp-server source-interface informs Loopback0 snmp-server enable traps snmp linkup snmp-server host 10.10.10.10 inform version 2c public With this configuration my management...

Sounds like something is limiting the number of lines you're receiving as output. I think maybe when you hit Enter on your keyboard there is another key being pressed. Try it from a different computer.

Does it exhibit this behavior through console and vty?

I've never experienced this problem before. I tried googling it but couldn't find a similar problem. If you do find out what's causing that please share it with us.

Hit the space key?

I'm not trying to monitor lo0, I'm trying to monitor when Async1 comes up. I just want the source-interface reported by the trap as lo0. The command snmp-server source-interface informs Loopback0 should do it but when I receive the trap the source-interface shows the ip address of FA0. The...

Turns out the new command for this is snmp-server source-interface informs Loopback0. It still doesn't work though, its still reporting the source interface as FastEthernet0 instead of LoopBack0. I've tried reapplying the commands, reloading the router ... still no luck.

I've been using SNMP traps to monitor when an interface on my routers comes up. Now I want to change from using TRAPS to INFORMs messages. When I change the configuration to use INFORMs I get the messages at my SNMP Manager but the trap-source is no longer the interface I specified. Here was...

I believe you need to set the privilege level to 15. Take a look at this link: http://www.xs4all.nl/~hermanb/cisco-ias.htm

The scheduled reload was the first thing that came to mind. We even use ntp. Unfortunately, my boss is not comfortable with that idea. We've decided to load the IOS on roughly 100 routers shortly before close of business. After close of business while someone is still on site, reload all...

That's what I was afraid of. Reloading routers in the wee hours of the morning it shall be then.