Search results for query: *

No - I am trying to connect over the internet to the SBC's FQDN. I put that WAN IP in the SIP Proxy and it sites at AQUIRING....It never connects through.

Thanks but i setup the SBC adn the phone to the WAN IP, a user in IPO and the NO User settings. But the phone keeps saying ACQUIRING SERVICE and I don't see it hit the SBC via TRACESBC? THoughts?

THanks! But i mean what are the settings on the J179? JP

Looking to setup a J179 through an SBC. Anyone have a cheat sheet or done this with notes? Thanks Much!!!

Additional Information: This is on all inbound calls DID over PRI into IP500 to the J129 or and Digital/Analog or any phone registered to the IPO. I see it hit the A1 interface on the SBC then get the 500 Server Error. But again, all 10 digit PSTN outbound from the J129 - to the SBC - to the...

I cannot for the life of me figure this out....I have IPO R10.1 with SBC 7.1 to a remote phone at a users home (J129). Phone is up and registered and i can call out via the IPO PRI line just fine. However, I cannot receiver inbound DID calls to the J129. It shows the invite going to the SBC...

I was told or thought you could do the setup? IP500 with SBC (Portwell). IPO is R10.1 and SBC is 7.1 How can i get a Avaya 9608 to register over the WAN through the SBC to the IPO? I have done remote worker installs including onex mobile for IPO but can i load SIP software on the 9608 and...

I thought this too. But in the trace the # is added from the CM. It shows the following on list trace station: Alert Trunk group 1 member 11 Digit # originated by station XXXX Digit # sent to trunk group 1 member 11 ???

Scenario - G450 with DS1 PRI to carrier. Carrier is delivering SIP trunk to ADTran then handing off PRI interface. On outbound calls...sporadically and almost always when an AA answers on other side we are seeing a # being added into the call via "list trace tac". This is then causing...

Anyone have any thoughts on this?

All - Need some assistance. I have AVP on S8300E in G450. The AVP is installed and fine. I tried (10 Times) to install the US VM on this and it hangs forever at the Running SANITY CHECK and then comes back with a Connection Error. The VM show failed to Deploy in current action on SDM Manager...

Best Forum Ever! Some help needed. I am installing a new location with an Avaya S8300E in a G450. I cannot locate or find the Avaya documentation for R7.1 (only 7.0) on what templates (VM's) can be installed on the S8300E. I just did a S8800 with CM, CMM, Utility, WeblM and SMGR. I was told...