Based on policy of priority queing,
it will affect the traffic flow.
Used custom queing, for traffice
managment, for the network.
Just for info,
tango2002
When there are two default routes, it
will get confused between choosing bri0
and 192.x.x.x, that will explain low latency,
I have run into this problem before.
Recheck your config....
Hope it helps,
tango2002
Two router simulations are available in the
market. Router sim for CCNA or CCNP...?? the take is..
One is from Sybex and another from routersim.
When I started on CCNP track, got it from Sybex CCNP ($199)
but it is nothing like real routers' (got three of 2500
series, on my own).
But the...
Well, if you are using frame-relay it will
gives you some problems with DCE and keepalives.
But if using x25, encap ppp, hdlc, it will be fine.
a. set ip on both routers to be same subnet.
b. set clockrate and dce, on dce side
c. set ip address - same subnet
It should works fine. I was...
tango2002 (Visitor) Nov 25, 2001
Need assistance...trying to prepare for CCNP..
I was trying to configure frame-relay and serial interfaces
comes up and went down after a few seconds, did sh frame
relay map and got this result..
Enviroment 2501 s0 (11.0 ver6) back to back to 2514 s1 (ver 11.3...
Need assistance...trying to prepare for CCNP..
I was trying to configure frame-relay and serial interfaces
comes up and went down after a few seconds, did sh frame
relay map and got this result..
Enviroment 2501 s0 (11.0 ver6) back to back to 2514 s1 (ver 11.3 ver 11.0).
Routez#sh frame-relay...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.