Guys,
this forum should be for us all to share our comments and concerns, but this is ridiculous. People are cutting and pasting messages from other forums and talking about financial success..... We all have our opinions about these two companies, but just answer the person's question. These...
YOu do need to get the NM-HDV module. The VWIC cards go inside of this. You would then need a VWIC-1MFT-T1. Connect this to a DS1 card on your G3. You will also need a 356A adapter for the PBX. This is an 8 port adapter that you will use to connect the router to the PBX. Use port # 8. Hope...
Ok, but then do you have to go into the cdr form and for the second output (I think that is what it says), put the extension of the data module? Or else, how does the switch know to send data to that station port?
filakio---Can you give me some more info on connecting devices using the TN754 circuit pack. We too have no open ports to use.
Thanks
Chris
cpwarren@renlearn.com
We've done it using a 2600 router.
ds1 board config
robbed-bit, esf, b8zs, leave the defaults
trunk group
wink/wink with defaults
cisco router
e&m wink start on the T1 controller
Ours works pretty well, just trying to figure out the best way to integrate Definity Audix.
Chris
Has anyone else experienced this......
Ever since the time change for daylight savings Arcserve starts the backup jobs an hour late. The server is set to the proper time and the proper time zone (GMT -6:00 Central). The Activity log shows that it starts an hour late, but if I look at the job...
Has anyone combined these two? Does anyone have any advice?
We are trying to figure out the best way to do this. We will have another location where we are going to install the Cisco AVVID system. We would like to connect it to the Definity G3 system at our main location and have 4 digit...
Can anyone help with this?
We are trying to link two PBXs together. They are currently linked with ds1 boards wich run to Paradyne CSU/DSUs which then connect over a T1.
We are going to be using an IP over SONET connection to connect the two sites in the near future and would like to get rid...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.