Search results for query: *

Also, to minimize the delay in forwarding calls to an external number, lower the "host delay" setting in [System Programming] [Feature settings] Host Delay = 200.

Yes, this can be accomplished. It took me a little bit to figure it out, but here's how it works. I have a MICS 5.0 system with DID's setup on a T1. I created a route which points to the primary outgoing line pool (Pool A). (Note: external forwarding only works through routes) When...

No. both systems wait two ring cycles before going off hook to listen for DTMF tones when trunks are setup with auto answer mode. Try it. Setup one trunk on a MICS, or CICS system for auto answer mode(No DISA). Call the telephone number for that trunk directly with a cellular phone. You...

I initialy used a but set make calls from one end of the circuit to the other. The MICS waits two rings before going off hook with a dialtone in auto answer mode. Can this be adjusted?

See Thread :VoIP Scenario, Need to change auto answer ring count on trunk cards. for clearification.

Systems: Office A: MICS 0x32 5.0 Office B: CICS 8x16 4.1 * We have two offices connected with a Point to Point T1 Circuit. * A Cisco 1760 router is located on each side of the circuit. * Each Cisco router has 2 FXS ports connected to a CI trunk card on both systems. * The trunks (lines)...

System: MICS 0X32 w/ MICS 5.0 software. I have a couple analog lines setup with "Ans Mode: Auto" and DISA set to No. These lines are connected to a VoIP gateway on each end of a Point To Point T1 Circuit. I would like to change the ring count in which the system waits to answer a trunk, and...