Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. EagleEyeTalon

    Server 2003 DNS / Domain Controller

    How different is it from Server 2000? I have lots of Server 2000 MCSE books
  2. EagleEyeTalon

    Server 2003 DNS / Domain Controller

    I am looking for some good tutorials on how to setup my 2003 server as a domain controller and DNS server on my internal network. I am running off of a cable modem and I am not looking to do anything but learn learn learn.
  3. EagleEyeTalon

    Proliant 3000 Memory Question

    I am looking to get some more memory for my server, but I am not sure if it will take it and I cannot find a compability chart on HP's site anywhere. The Part number for the memory is 228471-001 and I have a Compaq Proliant 3000 Dual P2 450's. Help....please
  4. EagleEyeTalon

    Smart Array 3200

    OK, so me and a co-worker each got a free server from a guy who no longer needed them. He got the external array but it seems that my server has the Smart Array 3200 card. The server is a Compaq Proliant 3000 / Dual P2 450s, 7 x 9.1 gig hard drives, 512 megs ram. My question: That Smart...
  5. EagleEyeTalon

    Installing Server 2003 on a Proliant 3000

    OK, figured it out. Turns out my internal hard drives came unplugged from the mother board some how.
  6. EagleEyeTalon

    Installing Server 2003 on a Proliant 3000

    OK, did that, when I boot to the CD, it does not always load and when it does, it does not run any of the configs. So I tried the compaq system config utility and it asked for the drive array diags disk....so I did that. I get an error on the diag. "Controller has no logical drive...
  7. EagleEyeTalon

    Installing Server 2003 on a Proliant 3000

    OK, I am having an issue as the guy in thread866-1121952 did. When I start up my server (that was given to me) it says that the array is not configured and then the 2003 Server Installation does not see hard drives. How do I configure the array?

Part and Inventory Search

Back
Top