Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. bmrouse

    Connecting CICS 1.0 to 824 DR5. with ATA2

    Curlycord, thanks for the help. I switched ATAs but no change. Allworxguy Thanks for your help. As it turns out, 824 DN capabilities set to external hotline was the problem. Removed the hotline setting and all worked well. Was able to successfully dial between two systems using line pool...
  2. bmrouse

    Connecting CICS 1.0 to 824 DR5. with ATA2

    That's right. 824 DN rings a DN on CICS. CICS DN gets busy signal when dialing 824 DN.
  3. bmrouse

    Connecting CICS 1.0 to 824 DR5. with ATA2

    Thanks for the response curlycord. I've benefitted much from your other posts in this forum. I tested both ATA wit a test set. Dial tone present. Trunk set to tones. F*809 set on both devices. Will swap ATAs to test. Thanks again.
  4. bmrouse

    Connecting CICS 1.0 to 824 DR5. with ATA2

    I've got two buildings on campus (one with CICS 1.0, other with M8x24 DR5) connected via DN to ATA2 to TRUNK. The CICS uses DN 2XX and the 824 uses 3XX. The CICS has one ATA2 installed on DN235 connected to 824 Line/CO7 and the 824 has one ATA2 installed on DN341 connected to CICS line 04...

Part and Inventory Search

Back
Top