Search results for query: *

Hi everyone Does anybody know the TACSU parameters to configure out DTMF CAS trunks by linkin a Hi Path 4000 (DIUN2) and a Hi Com (DIUC). At least DEVTYPE parameter might be useful. Thank you everybody

Does anybody knows how to do it?

Thank you. By the way, do you know how to install an HUBC card into a V1 Hi Path?

ISDN,E1 with Qsig signaling.

Trunks between Hi Path 4000

Hi!! I would like to install and enable a HUBC card in a Hi Path 4000 V1 PBX. How can I enable it?? Which slot is best suggested?? Do I need certain AMOs to do it?? I have seen this card allocated next to the DSCXL module. What are the main requirements needed to install HUBC?? I shall...

I am so sorry, yes you were right, I was looking for TDCSU configuration

Hi, How could I configure digital trunks with TSCSU? COP & COT parameters remain the same as analog TASCU as well? Thanks

Hi, I need someone’s help or support. I have configured E1 by CAS trunks through DTMF (DIUN2 Card). COT & COT are well defined but adding NTON parameter in order to avoid hearing next hop PBX tones. However, long periods when calling are noticed if several hops are given until final...

Hi, I need someone’s help or support. I have configured E1 by CAS trunks through DTMF (DIUN2 Card). COT & COT are well defined but adding NTON parameter in order to avoid hearing next hop PBX tones. However, long periods when calling are noticed if several hops are given until final...

[thumbsdown]

I’ll try and then after results I will tell if it worked out. Regards :)

Thank you Moriendi. I assume the CF (Hi Path 4000 V4) is empty, because the PBX had no inicial configuration but only Dongle values, BCSU equipment including all CSPi modules. I am going to do what you adviced based on STA-INIT AMO command. By the way, an error was shown when I typed COPY-DDS...

Oh I appreciate you took time to reply my post. I am going to apply your advices and procedure. Then only thing I do not certainly know is whether the CF is blank or empty in order to DEACT with DSSM. The CF was added by Siemens when the enterprise bought the Hi Path 4000 but has never been...

How can I save a copy from HD to MO in V1 and flash card in V4? Using DDSRM? Thank you

Hi. I have resolved this issue. I asked a friend to share the latest backups from general REGEN by VEGAS, etc, etc. I realised that the DONGLE codewords were different between 2006 backup and 2007. How could it be possible if no Siemens support was given at that time? ADD-CODEW: (new code)...

Thanks a lot. I have thought the HD is damaged or corrupt as you said because displays goes to 0 to 6 on and on. I isolated the HD and booted from MO. All cards in LTU turned OK and Q2270-X turned A. This means that MO works fine. Unfortunately, when I want to display configuration, there is an...

Help, I had a trouble: a Hi Path 4000 had to be turned off for changing its position into the telecommunications site. When it was connected to power supply again, system could not be booted. Display got boot process until number 6, and again 0...6. So, I used a MO disk that initially was...