Search results for query: *

Press any key to stop auto-boot... 7 6 a questo punto digitare un qualsiasi tasto per bloccare il boot [VxWorks Boot]: ? digitare ? per vedere il menù possibile ? - print this list @ - boot (load and go) p - print boot...

Try to stop boot , configure NBX to start with previous release

Yes , no NBX100 only V3000 or V5000 need upgrade memory Bruno

send me link how i can put patch by bruno

no only user and telephone group how 3 party sip phone . You must go on sip phone and configure - sip server your ip nbx - sip outbound proxy your ip nbx - user-id = your extension create in nbx - autenthication is = your extension create in nbx - password = default password if i remember...

simply , you ust create only a user example extension 2000 you must configure device using user 2000 password 1234 ( or psw voicemail ) , important timer expiry 3600sec

try this link http://www.nbxhelpdesk.com/main/

sorry you have enable nbx to sip ? had you ram necessary ? what nbx is ( 100 no sip enabled , v3000 , v3001 or v5000) what type third party you installed?

Sorry , have you also manual of hardware installation ? No software configuration i have it thanx Bruno

thanx soo much at all . bruno

Hi at all , i need software for configuration ipldk 300 . Anyone can send me software ? thanx

http://www.nbxhelpdesk.com/main/

go into Autoattendant / select menu that is deactive and press active

ok thanx below e2tshow -> e2tshow e2tshow Found an E2tProxySp. Will run e2tproxyShow as well -------------------------------- E2tProxySp Status -------------------- Local E2T has 64 Audio ports, and 128 T38 E2T Listening ports. Is Connected to E2tProxySp. Uses direct transcoding. E2T...

Hi Irwin , thanx soo much yes now i can connected on RTC via putty . But i have found new possible cause for my problem Duplicate IP Address , how i can verify what IP Address is assign on E2T? Log Number: 4950 Severity: Error Date: 2012/Nov/22 Time: 09:32:09 Source...

HI Irwin , i am try to connect via via putty but Mitel refuse connection i must use different port ? You are very expert to Mitel ,can you say me from logs below if TDM,PortID:13 is channel 13 of my ISDN PRI ? 1064 Date: 2012/Nov/23 Time: 10:51:26 Source: CCC_Ipsw Description...

hi yes issue is when from cucm make blind transfer to mitel but i need make sometime this tranfer and i found command for restart e2t w/o restart call server when issue occur sorry from command maintenance i cannot make e2tshow , i must connect via consolle cable?

Hi Irwin , about your question i have this HW Resource on my Mitel 3300 MXe T1/E1 w/dual inband loopback quad Bri(S/T) Quad BRI(s/t) 4 sharc 21161 dsp embedded echo cancellation 64 channel Where is E2T ? there are a chance to reboot this E2T? thanx

NO problem all software send correct outbound caller id via pretranslator You have problem with pstn / isdn E1-BRi / isdn-T1??

Hi at all , confirm all issue incoming when CIsco CUCM via trunk sip make a blind transfert to Mitel . Today i have allow this feature after 3h more logs with error