Search results for query: *

I have a 4GC card as a duplicate/slave with the red light on. What does this mean?

Thanks for the help. The solutions offered here worked on the first try.

Will a CFNA work on trunk lines that are mapped to buttons on the operator's phone?

Currently we have the system programmed to ring 3 times on mapped trunks to the Operator during the day. There is a Night Button programmed on the Operator phone. The night button will activate but the delay of three rings remains. How can the system be programmed to allow the Night Button to...

Currently when a call comes in it will ring 3 times at the Operator on mapped trunk appearances. Then it is answered by the Auto Attendant. What we want to happen is that the calls ring 3 times at the operator, then rings a hunt group 3 times, then the auto attendant should pick up. Any ideas...

Is anyone is aware of a way to change the remote notification numbers for voice mail using an analog remote phone calling in to an NBX 100.

I have to configure Unified Messaging on a BCM50 and I have never done it before. Where and how do I configure Unified Messaging? Thanks for the help.

It is my understanding that it is possible to pool TNs on Option 11 Succession switches. How is this possible? And what are the advantages?

There is a feature that goes out an tests digital ports and then turns them off if a digital phone is not found. Is there a command to turn ALL the ports back on? Is there a command to turn the feature off? Please provide detailed instructions for the commands as I am not a Nortel tech. Thanks...

OK, so it sounds like I'm stuck with the routine. Is there a way to turn ALL the ports back on? If so, how?

There is a feature that goes out an tests digital ports and then turns them off if a digital phone is not found. Is there a command to turn ALL the ports back on? Is there a command to turn the feature off? Please provide detailed instructions for the commands as I am not a Norstar tech...

Unless you are using the BCM for DHCP, then the IP phones need to be manually configured to use "partial" DHCP rather than "full".

LAN 1 is on an internal network that has a router that is NAT to a public IP address for the BCM. LAN 2 is not connected. According to snifs the BCM responds to the phones via the remote private IP address How do I configure a static route on the BCM?

Has anyone been successful in remotely deploying 2004 IP phones on a BCM 400 Rel. 4.0 without using VPN tunneling? If so, how did you do it? We have tried with the following results: Phones register with the BCM and boot up correctly; we can dial all types of calls; but we get NO talk path...